D-Link DCS-910/90 manual Security

Page 54

Section 4 - Security

Repeat the above steps adding the port 80 to both the Public and Private Port sections. A check mark appearing before the entry name will indicate that the ports are enabled.

Important: Some ISPs block access to port 80 and other commonly used Internet ports to conserve bandwidth. Check with your ISP so that you can open the appropriate ports accordingly. If your ISP does not pass traffic on port 80, you will need to change the port the camera uses from 80 to something else, such as 800. Not all routers are the same, so refer to your user manual for specific instructions on how to open ports.

Enter valid ports in the Virtual Server section of your router. Please make sure to check the box next to the camera name on the Virtual Server List to enable your settings.

D-Link DCS-910/920 User Manual

54

Image 54
Contents Page Table of Contents Warranty Registration Package Contents System RequirementsIntroduction Features Hardware Overview Front ViewReset Ethernet Connector Wireless Antenna Rear ViewAttach the Swivel Stand Hardware InstallationAttach the Antenna Connect the Ethernet CableAttach the External Power Supply Installation Wireless Installation Considerations Software Installation Click Setup WizardInstallation Installation Click Finish to complete the installation Installation Configuration Setup WizardConfiguration Click Restart Your setup is now completed Viewing Your Internet CameraConfiguration Setup Wizard Live VideoInternet Connection Setup Wizard Static IP Address, orConfiguration Network Setup This section, you can configure your network settingsSetup Wireless Wireless InterfaceSetup Ddns DdnsSetup Image Setup Image SettingsSetup Video Video ConfigurationSetup Mail Email AccountTime Schedule Interval Test E-mail AccountSetup FTP FTP ServerEnable upload image to FTP server Setup Time and Date Maintenance Device Management Maintenance Backup and Restore Maintenance Firmware Upgrade Status System ViewCam Installation Click D-ViewCamConfiguration Configuration Add a Camera Link D-ViewCamConfiguration DCS-910-55 DCS-910-55 DCS-910 Your D-ViewCam Installation is Complete Wireless Security What is WEP?What is WPA? Using & Configuring the DCS-910/920 Setting Up the DCS-910/920 For Use Behind a RouterAssign a Local IP Address to Your Camera Security Router Set-Up and Installation Access the Router with Your Web BrowserOpen Virtual Server Ports to Enable Remote Image Viewing Security Why does the LAN LED not light up properly? TroubleshootingWhy does the Power LED not light up constantly? Why does the Internet Camera work locally but not remotely?Noisy images occur. How can I solve the problem? Why are no images available through the Web browser?Wireless Basics What is Wireless? Wireless Local Area Network WlanHome Small Office and Home OfficeCentralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStep Highlight Internet Protocol TCP/IP and click Properties StepTechnical Specifications NetworkPower Consumption Contacting Technical Support Link Technical Support over the TelephoneLink Technical Support over the Internet Warranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesTrademarks Limitation of LiabilityGoverning Law Copyright StatementCE Mark Warning FCC StatementRegistration