Dual XDMA6330 owner manual General Operation, Faceplate Removal, Power On/Off Mode Auxiliary Input

Page 6

XDMA6330 OPERATION

General Operation

Faceplate Removal

Semi-Permanent Faceplate Installation

Power On/Off

Mode

Auxiliary Input

Steering Wheel Interface Input

Volume

Mute

Reset

Display

Set the Clock

Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.

Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate.

Press or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press and hold to turn the unit off.

Press MODE to select between AM/FM, CD player, iPod, USB, auxiliary input and Bluetooth modes. Modes of operation are indicated in the display.

Note: CD mode will not appear unless a CD is inserted. USB mode will not appear unless a USB device is connected. iPod mode will not appear unless an iPod is connected. Bluetooth mode will not appear unless the BTM60 Bluetooth module is connected.

Insert 3.5 mm plug to connect your portable audio device.

The steering wheel interface input located on the back of the head unit allows connection to the PAC (Pacific Accessory Corporation) SWI-PSinterface module (sold separately). Visit www.pac-audio.com for details.

To configure steering wheel controls, follow the instructions provided with the PAC SWI-PSinterface module. After installing the interface module, insert the module's 3.5mm jack into the port on the back of the head unit.

Adjust volume using volume knob (00-46).

Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.

Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate.

Press DISP to select between clock and different types of information, such as radio frequency, CD track or MP3/USB song information.

With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.

6

Image 6
Contents XDMA6330 Before You Start Please read entire manual before installationPreparation Getting StartedWiring Diagram RCA Preamp Output ConnectionsControl Locations Receiver Release Auxiliary Input Talk Preset 6 / Folder Up ModePower Mute / Loud EjectControl Locations Remote General Operation Power On/Off Mode Auxiliary InputVolume Mute Reset Display Set the Clock Faceplate RemovalSetup Menu Setup Menu 12/24-Hour ClockBass Treble Balance Fader EQ SUBWOOFER* Source Level Seek Tuning Manual Tuning Scan Tuning Band Preset ScanAM/FM Tuner Operation Pause Repeat Random Intro CD Player OperationInsert CD Eject CD Track Select CompatibilityWhen an MP3/WMA encoded disc is first inserted CD Player Operation MP3/WMA FilesCD Player Operation MP3/WMA Files Folder Access Repeat Random Intro Media Compatibility Playback Order Following types of discs/files are compatibleMP3 Tag Display Recommended Settings Transfer Bit ratesUSB Operation MP3/WMA Files USB Operation MP3/WMA Files USB Operation MP3/WMA Files MP3 Tag Display IPod Operation Connect iPod Not Included Displaying InformationReverse IPod OperationFast Forward IPod CompatibilityBluetooth Operation OverviewBluetooth Operation Mobile devices do not support this feature Bluetooth icon will flash every 10 secondsDisables Bluetooth support Disables the auto answer feature. Press toBluetooth Streaming Audio Operation Limited One Year Warranty What to do?Call us toll-free at Mail us at cs@dualav.com Troubleshooting General Problem Cause ActionDimensions 7 x 7 x 2 178 x 178 x 51 mm SpecificationsTuning range 87.5MHz-107.9MHz CD Player FM Tuner AM Tuner GeneralFCC Compliance XDMA6330 Operation XDMA6330 Operation Dual Electronics Corp Toll Free