XDM6350 OPERATION
General Operation
Faceplate Removal
Power On/Off
Mode
Auxiliary Input
Steering Wheel
Input Interface
Volume
Mute
Preset EQ Curves
Reset
Display
Set the Clock
Press RELEASE and pull away from the left side to remove. To
Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate.
Press or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press and hold to turn the unit off.
Press MODE to select between AM/FM, CD player, auxiliary input and USB. Modes of operation are indicated in the display.
Note: CD mode will not appear unless a CD is inserted.
Insert 3.5 mm plug to connect your portable audio device.
The steering wheel interface input located on the back of the head unit allows connection to the Pacific Accessory Corporation (PAC)
To configure steering wheel controls, follow the instructions provided with the PAC
Adjust volume using rotary encoder
Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.
Press EQ to enter EQ setup menu, then use the rotary encoder to select between POP, JAZZ, CLASSIC, BEAT, ROCK and FLAT (default) equalization curves. Any adjustment to the Bass or Treble settings automatically cancels the current EQ curve (if one is selected).
Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate.
Press DISP to select between clock and different types of information, such as radio frequency, CD track or MP3/USB song information.
With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.
6