General Operation, Faceplate Removal

MXD254B OPERATION

Faceplate Removal

Semi-permanent Faceplate Installation

Power On/Off

Mode

Loud

Auxiliary Input

Volume

Display

Set the Clock

12/24-hour Clock

Reset

General Operation

Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.

Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate.

Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off.

Press MODE to select between AM/FM, CD or auxiliary input. Modes of operation are indicated in the display.

Press and hold LOUD for 2 seconds to activate and deactivate the loud feature. Activating this feature will enhance the bass and treble frequencies when listening to music at low volumes.

Insert a 3.5mm connector in the front panel AUX port. Connect the other end of the 3.5mm connector to the headphone output of an audio device, MP3 player, etc. Press MODE to select AUX mode.

Adjust volume using the rotary encoder (00-46).

Press DISP to display the clock. The radio frequency (tuner mode) and CD track/elapsed time (CD player mode) will be shown by default.

Press DISP to display the clock, then release. Press and hold DISP for 2 seconds, the clock will begin to flash. Press TRACK nnto adjust the hours and TRACK llto adjust the minutes. Clock settings will be saved after 5 seconds.

The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).

Press and hold for more than 2 seconds to RESET the unit upon initial installation. The RESET button is located behind the faceplate.