Cable Wiring
The RSX series speaker connections are made via the rear panel ¼" and/or Speakon® connec- tors for easy interface with industry standard cables. Standard, unshielded speaker wire (avail- able at your local pro audio or music store), with either ¼" phone or Speakon connectors and wire gauge of
If your amplifier uses binding posts you can use speaker cables with banana connectors, but be sure to pay attention to the +/– polarity when making the connections. Make sure that the + ter- minal of the speaker, or banana connector, is connected to the + terminal of the power ampli- fier, and that the – terminal of the speaker, or banana connector, is connected to the - terminal of the power amplifier. It is important that your PA system is connected
Use the following diagrams below to ensure proper connections when wiring your system:
Unbalanced 1/4” Connector
Signal | Signal | Tip (signal) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Ground |
|
|
| ||||||
Ground |
|
|
| |||||||||
|
|
|
|
| Sleeve (ground) | |||||||
|
|
|
|
|
|
| ||||||
Speakon® Wiring Guide
SPEAKON®
+
- 
1- 1+
SPEAKON®
2+ 2-
NOT CONNECTED
RSX Passive Loudspeakers | 15 |