OPERATION
GENERAL OPERATION
•ON/OFF
Switch on the unit by pressing PWR button (1). When system is on, press it again to turn it off.
•SELECTING SOUND MODE
Press SEL button (6) to move display through volume, bass, treble, balance
and fader functions. Use VOL
(7) and VOL
(8) buttons to adjust the selected mode. When mode has not been adjusted for several seconds, display returns to previous display status (e.g. radio display or CDC display).
| VOL |
| BAS |
| TRE |
| BAL |
| FAD |
|
| (Volume) | (Bass) |
| (Treble) |
| (Balance) |
| (Fader) | ||
|
|
|
|
|
|
|
|
|
|
|
Volume
Adjust volume level using VOL 
(7) and VOL 
(8) buttons.
Bass
Press SEL button (6) for one time. Adjust bass level using VOL 
(7) and VOL 
(8) buttons.
Treble
Press SEL button (6) for two times. Adjust treble level using VOL 
(7) and VOL 
(8) buttons.
Balance
Press SEL button (6) for three times. Adjust sound balance between left and right speakers using VOL 
(7) and VOL 
(8) buttons.
Fader
Press SEL button (6) for four times. Adjust sound balance between front and rear speakers using VOL 
(7) and VOL 
(8) buttons.
•SELECTING PLAYING MODE When the screen display is drawn in, press MOD button (12) to select desired playing mode between radio and CDC. When the screen display is drawn out, the unit will automatically switch into TV mode.
By pressing MOD button (12), you can select desired playing mode among TV, radio and CDC.
CAUTION: The unit cannot be switched into TV mode, when the car is running. So at this time, you just select playing mode between radio and CDC.
•MUTE
Press MUT button (3) to cut down sound output, “MUTE” will appear on the display. Press it again to resume the previous volume mode.
•SETTING THE CLOCK
Press T/F button (5) to change the display into clock display. While the current time is appeared on the display, press it again to return to frequency showing.
Time Setting
-Set hours:
Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press TUNE/SKIP 
button (14) to adjust the hour.
-Set minutes:
Holding down T/F button (5) for several seconds, and the clock is blinking on the display, press TUNE/SKIP 
button (13) to adjust the minutes.
•LIQUID CRYSTAL DISPLAY
The LCD (4) can show the current state of the unit.
•RESET
Reset button (9) must be activated with either a ball point pen or thin metal object. The reset button is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
-Error symbol on the display.
10