OPERATION
TV OPERATION
•REMOTE SENSOR
On the screen display, there is a remote sensor IR (10) to receive remote control signal. You can point the remote control handset to IR (10) and press function keys on the handset to control TV.
The unit is also connected an external remote receiver (See the electrical connection diagrams on Page 7 & 8), and the function is the same with IR (10).
Notes:
-The external remote receiver is placed near the display for the best to receiver remote signal easily.
-If the display doesn’t stretch out, you cannot control the TV through the IR (10), and you must point the remote control handset to the external receiver.
-If the angle of the display from vertical exceeds ± 20° (Especially the distance exceeds 3m.), controlling the TV through IR (10) cannot get good effect. You are suggested to use the external remote receiver.
-In all playing modes, such as radio, CDC or TV, the POWER button (30) and the VOL + / – buttons (32 & 33) are available.
•ON/OFF THE UNIT
Switch on the unit by pressing POWER button (30). When system is on, press it again to turn it off.
•OPEN/CLOSE THE DISPLAY AND ANGLE ADJUSTMENT
-Press 
button (2) on the faceplate or point the remote handset to the external remote receiver and press 
(OPEN/CLOSE) button (31), the screen display will stretch automatically.
OPEN/CLOSE
Button (2)
Fig. 1
-When the display stretches to a certain location, it will turn upward automatically.
Fig. 2
-Adjusting the viewing angle.
The display will stop when it turns upward to a certain angle, then you can press ANGLE ADJ. + button (34) or ANGLE ADJ. – button (35) to turn the display upward or downward to a desired viewing angle. In this case, you need to consider if the IR (10) is available.
Fig. 3
-When you switch the POWER off or press 
button (2) or press
(OPEN/CLOSE) button (31), the display will turn downward automatically.
12