PYLE Audio PLVS7HM manual Installation Power Cord Female, Remote Control replacing batteries

Page 7

Installation

Power Cord

(Female)

Video 1 input (red)

Video 2 input (yellow)

Ground (black)

DC 12V power input (red)

Remote Control replacing batteries

PULL OUT

PUSH

1) Always use new batteries when replacing the old set.

2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 3)Battery replacement is necessary when remote control acts sporadically or stops

operating.

4)Do not drop, apply shock or step on the remote control 5)Do not spill water on the remote control

6)Do not place objects between the remote control and remote sensor. 7)Do not use remote controls for other equipments at the same time.

8)If the MONITOR does not operate even when operating the remote control from a close range, it is time to replace the batteries (use CR-2025), refer to the label on back of the basic control.

4

Image 7
Contents 7INCH Wide TFT LCD Monitor Precautions Control and layout for the monitor Control and layout for the remote control Function Page Remote Control replacing batteries Installation Power Cord FemalePage Setup work Step of install headrest housingCut the headrest MeasurementsRemove foam & obstructions Page Cut the visor Step of install sun-visor housingRoute the cable through the visor Install the sun-visor housingPage Page Display Size 7 Inch Wide Screen Diagonal