REMOTE CONTROL BATTERY
Back of the remote
Battery tank
Battery
Transparent slice
1.Always use new batteries when replacing the old set .
2.Do not attempt to
3.Battery replacement is necessary when remote control acts sporadically or stops operating this device.
4.Do not place objects between the remote control and remote receiver. 5.If the monitor does not operate even when operating the remote control from a colse rangre ,it is time to replace the batteries
Product number :(cr2025)
INSTALLATION
The device is an
ir eye .It will accept a video signal from any video source with composite videout .
1.Look over the vehicle for a location for the monitor .Each vehicle is different and locations will vary .Make sure the monitor will not interfere with the driver.
2.Once a location has been determined ,connect the IR ,A/V RCAs and Powercables to the designated sources.
3.Feed the cables through the hole in the mounting bracket and screw the bracket to the head liner ,Use short screws so as not to damage the roof.
4.Plug the cable into the monitors 6 pin din connector .Mount the monitor with the provided hardware.
Thank you for the purchase of this roof mounting 13inch
PREAUTIONS
The set is for use in DC12V ,negaive ground vehicles.
Do not operate the set in ways other than described in this guide .Doing so may damage it and may void your warranty.
SAFETY FIRST FOR REAR SEAT USE ONLY .Do not install on dashboard or any where else that would permit monitor to be viewed by the driver . Monitor must never be used in any manner that will distract driver or interfere with the drivers
safe operation of the monitor vehivle.
Be careful not to run down the car battery while using the set with the
car stopped.Do not disassemble or modify the set .Doing so may damage it and voids your warranty.
Keep drinks and drops from numberllas away from the set .Water may damage the internal circuitry.
Do not let the set become hot .If temperature in the car is high or the
set has been exposed to direct sunlight and is hot ,lower the temperature before using it .In extremely cold temperature ,the movement of the picture may be slow and the picture may be dark ,but this is not a malfunction .The set will work normally once the temperature increases.
4 | 1 |