Rockford Fosgate PCH-14X, PCH-414, PCH-514, PCH-614 manual S Ta L L At I O N, Mounting the Midrange

Page 9

Punch Splits speakers with minimum path length differences will ensure the best staging and imaging possible from your audio system.

IN S TA L L AT I O N

The mounting of the Punch Splits speakers and crossovers is just as important as choosing the location for the speakers. Improper installation will degrade the sound quality and reduce the reliability of the Punch Splits speakers. To maximize the performance of your speakers, the following criteria should be considered.

After choosing possible locations for the speakers, it is important to make sure there is a flat area large enough for the speaker to mount.

Warning !Failure to do this can cause damage to the speaker if the frame of the speaker is bent during the installation.

Check to see that the location is deep enough for the speaker and the location does not interfere with the normal operation of the vehicle.

When mounting the speakers in the door of a vehicle, special care should be taken to make sure the speaker/s do not interfere with either the window operation or the door opening and closing. (Be careful of the tension bar in the door.)

When mounting the speakers on the rear deck of the vehicle, double check the operation of the rear hatch or trunk lid. Make sure the tension bars and other moving parts are not obstructed by the speakers’ installation.

Refer to the Specifications section of the manual for the mounting depth and proper diameter hole to cut for the Punch Splits speakers.

Mounting the Midrange

1.Cut the proper size hole for the midrange/woofer.

2.Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.

3.Remove the ring. Drill the holes for the screws using a 1/8" drill bit.

4.Route the wire through the hole.

I

N S T A L L A T I O N

– 6 –

Image 9
Contents PCH-14X Practice Safe Sound B L E O F C O N T E N T S T T I N G S T a R T E DIntroduction Package ContentsPVA Treated Cone Technical Design FeaturesNeodymium Magnets Installation Considerations Tools NeededPlacing the Punch Splits Speakers T a L L a T I O N Mounting the Midrange S TA L L AT I O NSurface Mounting the Tweeter Flush Mounting the TweeterCrossover Installation Wiring the PCH-142xMounting the Punch Splits Plates Input Protection Wiring the PCH-314Crossover/Tweeter Protection Wiring the TX-4186Tweeter Level Matching Horizontal Logo MountingVertical Logo Mounting TR O U B L E S H O O T I N G Symptom Diagnosis RemedySN OI TA CI FI CE SP Limited WA R R a N T Y in F O R M AT I O N Length of WarrantyPage Lugar DE Montaje IntroducciónInstalación Montaje del altavoz de mediosMontaje superficial del Tweeter Montaje empotrado del TweeterAjuste de Nivel del Tweeter Conectando el PCH-142xEmplacement DE Montage InstallationMontage du haut-parleur médium Montage en surface du tweeter Montage encastré du tweeterBranchement du PCH-142x Compensation du Niveau AiguBranchement du TX-4186 Einbauort EinleitungMontage Montage des MitteltönersHochtöner-Aufbaumontage Festschrauben nicht verziehtVerkabelung des TX-4186 Frequenzweiche/Hochton Sicherung Verkabelung des PCH-142xInstallazione del Midrange InstallazioneIntroduzione PosizionamentoInstallazione a superficie del Tweeter Installazione ad incasso del tweeterRegolazione del livello di emissione del tweeter Cablare il PCH-142xPage Made in the USA