TR O U B L E S H O O T I N G
I N G
Symptom | Diagnosis | Remedy | |
|
|
| |
No sound from | Wires between amplifier, | Check and repair or | |
speakers | crossover and speakers | replace wiring as needed. | |
| not connected properly. |
| |
|
|
| |
| Amplifier has no output. | Check system with known | |
|
| working amplifier and re- | |
|
| pair or replace as needed. | |
|
|
| |
| Speaker wires are | Check for shorts in the | |
| shorted to each other or | wiring with a volt/ohm | |
| to the chassis of the | meter and repair or | |
| vehicle. | replaced wires as needed. | |
|
|
| |
| Speakers are blown. | Check system with known | |
|
| working speaker and repair | |
|
| or replace as needed. | |
|
|
| |
Tweeters “burn | Crossover is in “passive fil- | Check wiring and | |
up” easily | ter bypass” configuration. | ure as needed. | |
|
|
| |
| External crossover is not fil- | Check configuration of ex- | |
| tering the tweeter properly. | ternal crossover and | |
|
| figure for at least 6kHz @ | |
|
| 18dB/octave | |
|
|
| |
| Excessive clipping from | Check gain settings on am- | |
| amplifier. | plifier and readjust as | |
|
| needed. | |
|
|
| |
| Equalizer in system (if avail- | Check settings on equalizer | |
| able) has excessive boost in | and readjust as needed. | |
| the high frequency range. |
| |
|
|
| |
Distorted sound | Incorrect wiring between | Check wiring and repair | |
from speakers | crossover and speakers | or replace as needed. | |
|
|
| |
Engine Noise | Speaker wires shorted | Check for shorts in the wir- | |
to chassis of vehicle. | ing with a volt/ohm meter | ||
from One | |||
| and repair or replace wires | ||
or More |
| ||
| as needed. | ||
Speakers |
| ||
|
| ||
| Crossover is mounted near | Move crossovers away from | |
| radiated noise source. | noise sources. (Refer to In- | |
| (Power cables, computers, | stallation section of manual | |
| etc.) | on crossovers.) | |
|
|
|
– 12 –