Radio Shack FCC User Information, Main Components Vu Qube V10 Antenna Vu Qube V10 Remote

Page 5

FCC User Information

Main Components

Vu Qube V10 Antenna

Vu Qube V10 Remote

 

 

Part #: VQV10

Part #: VQV10R

FCC ID: UUM10156V10

FCC ID: UUM10157V10

IC: 6873A -10156V10

IC: 6873A -10157V10

 

 

This device complies with Part 15 of

This device complies with Part 15 of the

THEH&## RULES /PERATIONIIS SUBJECT TOS

&###RULES /PERATIONIIS SUBJECT TOSTHEB

the following two conditions:

following two conditions: 1) This device

1) This device must not cause harmful

must not cause harmful interference, and

interference, and 2) This device must

2) This device must accept interference

accept interference received including

received including interference that may

interference that may cause undesired

cause undesired operation.

operation.

 

 

 

Please note that changes or modifications to the Vu Qube V10 or

Vu Qube V10 remote not expressly approved by Wallace Technologies could void the purchaser’s or user’s authority to operate this equipment.

This device must not be co-located with other transmitters to ensure compliance with FCC RF exposure requirements.

The Vu Qube V10 and Vu Qube V10 remote have been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

ss 2EORIENT ORERELOCATE THE RECEIVING ANTENNA

ss )NCREASE THE SEPARATIONEBETWEENPTHEREQUIPMENTNANDBTHETRECEIVER

ss#ONNECTNTHECEQUIPMENTEINTO ANUOUTLET ONNATCIRCUIT DIFFERENTEFROM THATTTO which the receiver is connected.

ss #ONSULTSTHELDEALER OREAN EXPERIENCED RADIO46DTECHNICIANCFOR HELP

Vu Qube

5

V10-6/1007

Image 5
Contents Installation Operating Manual Introduction Technical SupportBackground Mounting Kit Purchased Separately Vu Qube V10 Component OverviewMain Components Vu Qube V10 Antenna Vu Qube V10 Remote FCC User InformationOverview of Installation InstallationMounting the bracket and selecting location to run wiring Place Vu Qube on bracket Mounting Antenna to BracketWiring Fine tune and maximize signal using all 4 arrows Finding the Satellite and Acquiring a SignalVu Qube V10 Operation If you experience difficulty contact 866Satellite Position Memory TroubleshootingLimited Warranty Maintenance