Installation (continued)
2.Drill holes for mounting bracket with proper size depending on fasteners used.
./4% The installer is responsible for determining the most appropriate fastener to secure the bracket to the cab. Depending on the cab material, fasteners such as lag screws, well nuts, sheet metal screws, toggle bolts and T anchors may be used. Fasteners should always be used in combination with compatible sealant to environmentally seal the holes after installation.
3.Mount bracket to cab using fasteners.
4.Seal holes with a sealant compatible with cab, faring, or air shield material, depending on where Vu Qube is mounted.
5.Drill hole to pass the harnesses inside the vehicle.
./4% It is an option to run the wiring down the back of the cab and up into the cab through an access bay.
Mounting Antenna to Bracket
1.Place Vu Qube on bracket.
ss#OAXIALXCABLE CONNECTIONS FROMTTHEO6UU1UBE &IGURE &SHOULD BE positioned toward the cab (front of the vehicle) and to side where hole is drilled to run wires inside the cab.
Figure 2. Face connections for wiring towards the back of the cab.
Back of cab
Coaxial Cable Connection
Face towards back of the cab.
Position connector on side you will run coaxial cable.
2.Secure Vu Qube to bracket by fastening with nuts provided.
Be sure to tighten nuts adequately to ensure Vu Qube is securely in place.
Vu Qube | 8 |