(11) VOLUME CONTROL
Controls the overall volume level of the amplifier. The final level adjustment should be made after the desired sound has been achieved.
(12) LINE OUT—XLR JACK
Provides 600 Ohm,
(13) LINE OUT LEVEL CONTROL
Controls the output level of the balanced line level output (13).
(14) PRE-/POST-EQ SELECT SWITCH
Allows selection between a
(15) GROUND LIFT SWITCH
Provided to lift the ground on the XLR jack when ground loops are encountered.
(16) EFFECTS SEND JACK
Output for supplying signals to external
(17) EFFECTS RETURN JACK
Input for returning signals from external
(18) EFFECTS LOOP REMOTE SWITCH JACK
This jack accommodates the remote footswitch (optional part number 00051000 ON/OFF single button switch), which is used to remove the effects loop from the signal path. The remote footswitch essentially acts as a bypass to punch in or punch out from your external effects.
(19) DDT™ COMPRESSION DEFEAT SWITCH
DDT™ compression is defeated when the push button is in the “in” position. We recommend that DDT be enabled at all times to protect the speakers.
(20) PREAMP OUT JACK
This 1/4" jack is used to route the preamp signal to external inputs, such as the input of an additional power amp. The signal is post volume control. Use of this jack does not defeat the signal to the MAX 700 amp (some volume difference may be noticed due to the impedance change experienced when adding an
external unit to the signal patch).
(21) POWER AMP IN JACK
This 1/4" jack is used to input an external signal to the power amp section of the MAX 700. Using this jack will disconnect any signal from the preamp section. Using this jack along with the preamp out jack creates a possible second effects loop.
(22) CROSSOVER FREQUENCY CONTROL
Determines the crossover frequency of the internal electronic crossover. Adjusting this control will set the frequency range of the signals found at the high out and low out jacks. The crossover frequency can be adjusted from 100 Hz (.1 k) to 1000 Hz (1 k).
(23) CROSSOVER BALANCE CONTROL
Balances the amount of low and high signals found at the low and high out jacks. Use care with this control, especially when using separate cabinets for lows and highs. Since different cabinets often do not share the same sensitivity characteristics (some cabinets are naturally louder than others) this control can be used to compensate in order to “balance” the two.
(24) LOW OUT
This 1/4" jack supplies the low frequency signal determined by the crossover frequency control and the crossover balance control. Use this jack to route the signal to an external power amp or to the power amp input of the MAX 700 when signal separation is desired. Use of this jack does not defeat the low
frequency signal going to the power amp section.
6