Peavey Max 700 operation manual Rear Panel

Page 8

Rear Panel

27

28

31

32

31

29 30

(27) GROUND POLARITY SWITCH

Three position, rocker-type switch, which for most applications should be operated in the center (zero) position. If hum or noise is present with the ground switch in the center position, place the ground polarity switch to positive or negative (+ or -) to minimize hum; should a problem continue, consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician. NOTE: The ground switch is not functional on 220/240 Volt models.

(28) RESET/CIRCUIT BREAKER SWITCH

Use this switch to restore power to your unit when the internal breaker is tripped. The proper method is to turn the power switch to the “off” position before resetting the breaker. To reset, push the reset button in and release it. Turn the unit back on and confirm that the power LED is on. If the breaker is tripped again upon power-up, consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician.

(29) POWER SWITCH

This switch is used to turn the MAX 700 on or off. To turn the unit on, flip the switch to the “on” position.

(30) IEC CONNECTOR/DETACHABLE LINE CORD

For your safety, we have incorporated a detachable, three-wire line (mains) cord with proper grounding facilities. It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the amp without proper grounding facilities, suitable grounding adaptors should be used. Greatly reduced shock hazard exists when the unit is operated with properly grounded receptacles. Connect the IEC plug of your cord to the IEC socket on the rear of your unit. Refer to the back of your unit for the proper voltage required before connecting to a power receptacle.

(31) POWER CORD RETAINERS

Use the Power Cord Retainers to wrap and store your cable while storing or transporting your MAX 700. It is best to disconnect the cord from the unit before wrapping.

(32) SPEAKER OUTPUT JACKS

These two 1/4" jacks provide the powered signal from the amplifier. Each connector is electrically the same (in parallel). Use one of the jacks to connect your speaker cabinet and the other to add a second speaker cabinet in parallel. The minimum speaker load impedance is 2 Ohms (or two 4 Ohm speakers in parallel). WARNING: To prevent the amplifier from overheating, the front fan and rear-located vents should always remain clear of obstructions.

8

Image 8
Contents Page Page Important Safety Instructions Features EnglishFront Panel Volume Control PRE-/POST-EQ Select SwitchGround Lift Switch Effects Loop Remote Switch JackSTATUS/POWER LED High OUTRear Panel Power Amplifier Section Preamp SectionLB Mco Ak X aiD 7g 00 mar MAX Español CaracterísticasPanel Frontal Control DE Nivel DE Salida DE Línea Interruptor Selector Previo O Posterior a EcualizaciónInterruptor Para Eliminación DEL Circuito DE Tierra Enchufe Hembra DE Señal DE Muestra DE EfectosSalida Alta LED Indicador DE ESTADO/ALIMENTACIÓNPanel Trasero Especificaciones Francais CaractéristiquesPanneau Arriere Prise DE Pédale DE Commande DE LA Boucle D’EFFET Entrée Power AMP14 Sélecteur PRE-/POST-EQ 15 Sélecteur Ground LiftPanneau Arriére MAX Deutsch MerkmaleFunktionen an der Vorderseite Power AMP in Buchse Line OUT PegelreglerPRE-/POST-EQ Wahlschalter Masse TrennschalterSTATUS/NETZ LED Rückseite Spezifikationen Page Page Page 80304958