Orion Car Audio RGC2 owner manual Front Panel, Rear Panel

Front Panel

(2)REMOTE GAIN CONTROL

MIN MAX

(1) ILLUMINATED RING

The front panel of the RGC2 consists of:

1.LED illuminated outer ring - which will glow (when the power connections are made).

2.Remote Gain Control - Rotate clockwise to increase the amount of gain, or counter- clockwise to reduce the gain. This control can be recessed by pushing on the control.

Rear Panel

GND	+12V
(1) TWO-WIRE
LED HARNESS		(2) 3.5mm “MINI”
LED
		PHONE JACK

The rear panel has 2 connections:

1.A two-wire harness allows control of the illumination of the LED. Connect the Red + wire to a illumination control output, or to a source of 12-15V power (current draw is less than 20mA). Connect the Black or GND lead to a convenient power ground. The control and illumination circuits are independent.

2.A standard 1/8" (3.5mm) "mini" phone jack connects the gain control knob to the cor- responding amplifier via a 2 conductor, 15 foot cable. Connect the other connector to the remote jack on the amplifier.

Attach the body of the unit to the underside of the dash using 2 screws on either side of the control housing.

Note: The control can be removed from the housing if flush-mounting is desired. Remove the two hex head screws at the side. Remove the 2 Phillip’s head screws secur- ing the PCB. Remove the ring retainer on the front of the control, and then remove the PCB.

Note: Before drilling any holes verify that there are no obstructions (wiring, ventila- tion, etc) on the other side of the dash.

2 © 2009 Directed Electronics—All rights reserved.