Orion Car Audio CO552, CO652 owner manual Installing the Crossover, Figura Abbildung Flush Mount

Page 7

Step 5: Install tweeter in flush mount housing..

Step 6: Connect the speaker wires observing the correct polarity..

Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface..

Step 8: Use the supplied pressure ring to secure the housing to the surface..

Flush Mount

Tweeter

Assembly

Tweeter Cup

Pressure Ring

Figure 5

Figura 5

Abbildung 5

Flush Mount	Tweeter
Trim Ring	Wire

Panel

Wiring Harness

Installing the Crossover

Step 1: Find a location for the crossover away from any factory or after market electrical wires.. It is recommended to mount the passive crossover close to the amplifier..

Step 2: Mount the crossover using the supplied wire ties..

Step 3: Connect the wires.. Make sure the speaker wires for the midrange go to the mid/ woofer output and the tweeter to the tweeter output.. Be sure to observe the correct polarity.. Changing the polarity of the tweeter may be necessary for optimum sound quality..

6	© 2008 directed electronics—all rights reserved

Image 7

Contents Component Speaker Introduction Table of ContentsPractice Safe Sound Finding Speaker Mounting Locations Installing ProcessWhat’s in the Box Tools of the Trade Rear Deck Mounting Door MountingInstalling the Mid/Woofers Surface Mounting Installing the TweeterFull Flush Mounting Figura Abbildung Flush Mount Installing the CrossoverWiring Diagram Features SpecificationsMontage SUR UNE Portière Installation DES HAUT-PARLEURS Médiaux ET DE GravesFrançais OÙ Monter LES HAUT-PARLEURSMontage EN Surface Installation DU HAUT-PARLEUR DaigusMontage Encastré Spécifications Installation DU RépartiteurCaractéristiques Page Montaje EN LA Repisa Trasera EspañolUbicaciones DE Montaje DE LOS Altavoces Montaje EN LA PuertaMontaje EN Superficie Instalación del TweeterMontaje AL RAS Especificaciones Instalación DEL CrossoverCaracterísticas Page Einbau IM Kofferraum DeutschSO Platzieren SIE DIE Lautsprecher TüreinbauOberflächeneinbau Einbau des HochtönersBündiger Einbau Daten Installation DER CROSSOVER-EINHEITEigenschaften Page Montaggio NEL Piano Portaoggetti Posteriore Installazione DEI MIDRANGE/WOOFERItaliano Montaggio Sulle PortiereMontaggio a Superficie Installazione del tweeterMontaggio a Filo Dati Tecnici Installazione DEL CrossoverCaratteristiche Page Instalação no Painel Traseiro PortuguêsDeterminação DOS Locais Para Instalação DOS ALTOS-FALANTES Instalação NAS PortasInstalação NA Superfície Instalação do tweeterInstalação Embutida Especificações Instalação do CrossoverPage Warranty