Installing the Tweeter, Surface Mounting

Installing the Tweeter

SURFACE MOUNTING

Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location..

Step 2: Place the provided template or tweeter cup against the panel and mark the two holes at the rear of the housing..

Step 3: Drill the smaller holes using a 1/8" drill bit.. These are the mounting screw holes..

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill..

Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet and route the speaker wire from the crossover through the grommet..

Step 5: After removing the surface mount tweeter assembly trim ring, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover.. (See Figure 4..)

Step 6: Insert the excess speaker wire into the hole and position the housing so the housing will not pinch the wires after final mounting..

Step 7: Attach the housing using the supplied screws of the correct length for a solid mount..

Step 8: Insert the tweeter into the housing and attach the surface mount trim ring..

Surface

Mount Trim Ring

Mounting

Screws

Surface Mount Housing

Figure 4
Figura 4
Abbildung 4	Tweeter

Tweeter Wire

Wiring

Harness

Panel

FULL FLUSH MOUNTING

Step 1:. Determine where the tweeter will be mounted.. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area..

Step 2: Using the back half of the tweeter housing, mark with a pen the hole needed for the tweeter..

Step 3: Be sure the hole is large enough for the tweeter housing, but not so large that the flange will not cover the hole.. .

Step 4: Cut the hole for the tweeter.. When using factory locations, this step can be skipped.. A hole can be cut either with a pair of metal tin snips or a 1-7/8" hole saw for hard materials..

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill..