Orion Car Audio HCCA1002 owner manual Full Flush Mounting, Figura Abbildung

Page 6

FULL FLUSH MOUNTING

Step 1: Determine where the tweeter will be mounted.. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area..

Step 2: Using supplied template mark with a pen the hole needed for the tweeter..

Step 3: Be sure the hole is large enough for the tweeter housing..

Step 4: Cut the hole for the tweeter.. When using factory locations, this step can be skipped.. A hole can be cut either with a pair of metal tin snips or a 2" hole saw for soft materials or 2-1/8" hole saw for hard materials..

WARNING: Check for clearance of window mechanisms and electrical wires BEFORE you drill..

Step 5: Install tweeter in flush mount housing..

Step 6: Connect the speaker wires observing the correct polarity..

Step 7: Install tweeter and housing in the hole cut for mounting, so that the trim ring is flat with the front of the surface..

Step 8: Use the supplied pressure ring to secure the housing to the surface..

FLUSH MOUNT
	TWEETER
	ASSEMBLY
FLUSH		TWEETER
FLUSH		TWEETER
MOUNT		CUP
TRIM RING

PRESSURE RING

Figure 2

Figura 2

Abbildung 2

	TWEETER WIRE	PANEL

WIRING HARNESS

© 2010 directed electronics—all rights reserved

5

Image 6

Contents Component Speaker Table of Contents Introduction Practice Safe Sound TOOLS OF THE TRADEDoor Mounting InstallationFinding Speaker Mounting Locations Rear Deck MountingInstalling the Tweeters Surface MountingFull Flush Mounting Figura AbbildungInstalling the Crossover FiguraSpecifications FeaturesPage Montage Dans LA Porte Choix DES Emplacements DE Montage DES HAUT- ParleursFrançais Montage SUR LA Plage ArrièreInstallation DES HAUT-PARLEURS D’AIGUS Montage EN SurfaceMontage Totalement Encastré Installation DU Filtre Spécifications CaractéristiquesMontaje EN LA Puerta EspañolUbicaciones DE Montaje DE LOS Altavoces Montaje EN LA Repisa TraseraInstalación DE LOS Tweeters Montaje EN SuperficieMontaje AL RAS Instalación DEL Crossover Especificaciones Modelo HCCA1002Türeinbau DeutschSO Platzieren SIE DIE Lautsprecher Einbau IM KofferraumInstallation DER Hochtöner OberflächeneinbauKabelbaum Installation DER CROSSOVER-EINHEIT Technische Daten MerkmaleItaliano Montaggio Sulle PortiereInstallazione DEI Tweeter Fissaggio SU UNA SuperficieMontaggio a Filo Installazione DEL Crossover Dati Tecnici CaratteristicheInstalação NAS Portas PortuguêsDeterminação DOS Locais DE Instalação DOS ALTOS-FALANTES Instalação no Painel TraseiroInstalação DOS Tweeters Instalação NA SuperfícieInstalação Embutida Instalação do Crossover Especificações Warranty