Orion Car Audio HCCA1002 owner manual Installing the Crossover, Figura

Page 7

INSTALLING THE CROSSOVER

There is a tweeter level jumper for adjusting the tweeter.. Cutting this jumper will change the output gain of the tweeter.. Where the adjustment should be depends on the location of the tweeter and your preference.. Adjustments can be made from 0dB to -3dB by cutting the "level jumper".. Tweeter phase can be changed by reversing the polarity of the amplifier output wire connections to the crossover.. If the tweeter is within 6" of the woofer center the tweeter should be in phase with the woofer.. If the tweeter is further than 6" from the center of the woofer, both in phase and out of phase should be tried to see which is best..

Use wire tie or screws to secure crossover housing in place..

Figure 3

 

Figura 3

To Tweeter

Abbildung 3

-

+

Level jumper

Note: Jumper is under top cover of crossover housing.

Remarque : Le cavalier se trouve sous le couvercle du boîtier du filtre.

Nota: El puente está debajo de la tapa de arriba del alojamiento del crossover.

Hinweis: Der Jumper befindet sich unter dem Deckel des Crossover-Gehäuses.

Crossover Nota: il ponticello si trova sotto il coperchio superiore del supporto del crossover. Nota: O jumper está embaixo da tampa superior da carcaça do crossover.

Amplifier

+

_

Note: The tweeter positive is the wire marked with the stripe.

Note: Le câble positif du haut-parleur d'aigus est rayé.

Nota. El positivo del tweeter es el cable que tiene la franja.

Hinweis: Der positive Hochtönerdraht ist mit dem Streifen markiert.

Nota: il filo positivo del tweeter è contrassegnato da una striscia.

Nota: O cabo positivo do tweeter está marcado com a listra.

6

© 2010 directed electronics—all rights reserved

Image 7
Contents Component Speaker Introduction Table of ContentsTOOLS OF THE TRADE Practice Safe SoundRear Deck Mounting InstallationFinding Speaker Mounting Locations Door MountingSurface Mounting Installing the TweetersFigura Abbildung Full Flush MountingFigura Installing the CrossoverFeatures SpecificationsPage Montage SUR LA Plage Arrière Choix DES Emplacements DE Montage DES HAUT- ParleursFrançais Montage Dans LA PorteMontage EN Surface Installation DES HAUT-PARLEURS D’AIGUSMontage Totalement Encastré Installation DU Filtre Caractéristiques SpécificationsMontaje EN LA Repisa Trasera EspañolUbicaciones DE Montaje DE LOS Altavoces Montaje EN LA PuertaMontaje EN Superficie Instalación DE LOS TweetersMontaje AL RAS Instalación DEL Crossover Modelo HCCA1002 EspecificacionesEinbau IM Kofferraum DeutschSO Platzieren SIE DIE Lautsprecher TüreinbauOberflächeneinbau Installation DER HochtönerKabelbaum Installation DER CROSSOVER-EINHEIT Merkmale Technische DatenMontaggio Sulle Portiere ItalianoFissaggio SU UNA Superficie Installazione DEI TweeterMontaggio a Filo Installazione DEL Crossover Caratteristiche Dati TecniciInstalação no Painel Traseiro PortuguêsDeterminação DOS Locais DE Instalação DOS ALTOS-FALANTES Instalação NAS PortasInstalação NA Superfície Instalação DOS TweetersInstalação Embutida Instalação do Crossover Especificações Warranty