Craftsman 315.22811 To Install Accessory Table and RIP Fence, Hole B Tableslot Accessory

TO INSTALL ACCESSORY TABLE AND RIP

FENCE

m! Place the accessory table on the front and rear rails, fitting the tip into the rear rail. Position the slot on the underside of the accessory table onto the front rail and tighten the lever securely. See Figure 15.

•Screw the locking handle into the rip fence mounting hole. See Figure 16.

•Remove the scale indicator assembly from the plas- tic bag and install on either side of the fence. The

pan head screw (#8-32 x 1/2 in.) goes on the outside of the front block. The scale indicator and hex nut

(#8-32) go immediately behind the front lip of the front block.

•To install the rip fence, place the rear lip on the rear rail and pull slightly toward the front of the unit. Lower front end onto the guide surfaces on top of the front rail. Check for a smooth gliding action. Swing the locking handle down to automatically align and se- cure the fence. When securely locked, the locking handle should point downward.

,_, WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury.

C.BLADECHECKAND BLADE GUARD

ASSEMBLY

TO CHECK SAW BLADE INSTALLATION

•To check the saw blade, first remove the three screws holding the throat plate in place. Remove the throat plate. See Figure 17.

•Make sure the bevel locking lever is securely pushed to the left. Raise the blade arbor to its full height by turning the blade adjusting handle clockwise.

•Using the smaller hex wrench, insert the flat open end into the flats on the arbor shaft as shown in

figure 18. Insert the larger hex wrench over the hex nut, and, holding both wrenches firmly, pull the larger wrench forward to the front of the machine to loosen and push to tighten. Make sure the blade nut is securely tightened. Do not overtighten.

Note: Arbor shaft has left hand threads.

•Check all clearances for free blade rotation.

•See To Set the Scale to the Blade in the

Operation Section. In cutting operations, the scale will be set to the side of the blade where the cut will be measured and made.

ADJUSTINGCLAMP

MITER FENCEATrACHMENT

BOLT

MITER FENCE

INDICATOR
HOLE "B" TABLESLOT	Figure 14
ACCESSORY
TABLE
	REAR RAIL
UNLOCK _

	FIT LIP OF TABLE
	INTO REAR RAIL
TO
LOCK LEVER	Figure 15
	RIP FENCE
FRONT	REAR LIP
RAIL

REAR RAIL

SCREW	HEX NUT
	LOCKING HANDLE
SCALE INDICATOR		FRONT LIP	Figure 16

19 I:RRFTSNRN" TABLESAW315.228110