Craftsman 315.22811 To Install Miter Table and Fence, Endcap Frontrail Scale, RAi, Holdernut

WARNING: Do not connect to power supply until assembly is complete. Failure to comply

could result in accidental starting and possible serious injury.

B.ASSEMBLY OF RAILS, TABLES, AND

FENCES

TO INSTALL FRONT AND BACK RAILS

•Position end caps on both rails and secure in place by tapping with a block of wood or a rubber mallet.

•Loosen the front rail clamps one-half (1/2) turn from the tightened position. Loosen the square rail holder nut one-fourth (1/4) turn to allow the front rail to slide over it. See Figures 11 and 12.

•Mount the front rail with the scale facing the outside toward the operator.

•Check to make sure the rail clamps will securely clamp the rail before sliding the entire assembly into position. If not, repeat steps 2 and 3 above.

•Slide the rail into position over both clamps and secure.

•Mount the rear rail, following the same clamping procedure as shown for the front rail. Orient the rear rail as shown in figure 12.

TO INSTALL MITER TABLE AND FENCE

•Install the sliding miter table assembly over the front and rear rails. See Figure 13. Check that it slides easily on the rails. Push both front miter locking clamps down evenly on each side to secure. Repeat for both rear miter locking clamps. Note: Do riot force miter locking clamps fully down. Tighten only to flat "seated" position.

•To install the miter fence holder to the miter fence, loosen the attachment bolt by turning the adjusting clamp (the knob on top) counterclockwise. Make sure the adjusting clamp is loose enough so the bolt has enough clearance to slide in the table slot. Slide the tabs into the grooves in the miter fence. See Figure 14.

•Mount the miter fence to the miter table by install- ing the Iocator pin (below the miter fence) into hole "A" or "B". (Hole "A" is closest to the blade). At the same time, place the attachment bolt in the slot. Secure the adjusting clamp, but do not tighten.

Note: Hole "A" should be used fo,_short pieces of wood and hole "B" shouSdbe used for Songpieces of wood.

•Adjust the miter indicator to the scale.

•Retighten the adjusting clamp.

ENDCAP FRONTRAIL

SCALE

LOCKING

FRONT LEVER BLADE

RAIL CLAMP	ADJUSTING HANDLE Figure 11
	END CAP REAR RAIL

RAi

HOLDERNUT

Figure 12

MRER

TABLE BASE

REAR

RAIL

Figure 13

CRAFTSMAN"TABLESAW315.22811018