Craftsman 315.22811 owner manual Blade is dull, Slow the feed rate, Align the rip fence

[ Problem		Cause		Solution	I
Excess vibration.	Blade	is out of balance.	Replace	blade.
	Blade	is damaged.	Replace	blade.
	Saw is not mounted securely,		Tighten	all hardware.
	Work	surface is uneven.	Reposition on flat surface.
			Adjust legs of optional stand.
	Blade	is warped	Check Saw Blade Installation on
			page 19. Replace blade if neces-
			sary.
Rip fence does not move smoothly.	Rip fence not mounted correctly.		Remount the rip fence.
	Rails are dirty or sticky.		Clean and wax rails.
	Clamp screw is out of adjustment.		Adjustclampscrewcountemlockwise.
Rip fence does not lock at rear.	Clamp screw is out of adjustment.		Adjust clamp screw clockwise.
Cutting binds or burns work.	Blade is dull.		Replace or sharpen blade.
	Blade is heeling.		Align miter base.
	Work	is fed too fast.	Slow the feed rate.
	Rip fence is misaligned.		Align the rip fence.
	Riving knife is misaligned.		Adjust the rivingknife with shims
			provided,
	Wood is warped.		Replace the wood. Always cut with
			convex side to table surface.
Wood edges away from rip fence	Rip fence is misaligned.		Check and adjust the rip fence.
when ripping.
	Blade not properly sharpened or set, Re-sharpen or set blade,
Sliding miter table assembly does	Miter base or slides improperly		See page 37 for Adjustments		To
not move smoothly.	adjusted.		Sliding	Miter Table Assembly

CRAFTSNAN"TABLESAW315.22811044