Craftsman 315.22811 Assembling LEG Stand, Leveling feet, Fiat washers 5/16 Hex nuts 5/16-18

Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until you have obtained the missing part(s).

A. ASSEMBLY OF LEG STAND, STORAGE BRACKETS, AND MOUNTING TO SAW

ASSEMBLING LEG STAND

See Figures 8 and 9

•Take the fottowing hardware from the teg stand hardware bag:

24 carriage bolts (5/16-18 x 3/4 in)

4 leveling feet

32 fiat washers (5/16 in)

32 hex nuts (5/16-18)

Note: Remaining hardware from this bag is used for mounting leg stand on the table saw base and mounting storage brackets to upper brace.

•Take 4 legs and 8 braces from loose parts.

•Place an upper side brace inside two of the legs,

with the legs wide end up. (Upper side braces have two large holes in each end.) Make sure the two posts on the leg align with the small holes on the brace.

Align the two large holes on the brace and the legs. Insert the carriage bolts. Add flat washers and hex nuts and hand tighten. Repeat for the

other upper brace. These are the front and back sets.

•For the side sets, install a upper brace on two legs. Add hardware and finger tighten. Repeat for the other upper brace.

•Use the same steps to install the lower braces. Tighten all hex nuts with a 12 mm wrench.

•Place a hex nut and flat washer on each leveling foot. Install the leveling feet from the bottom of

UPPERBRACE

BOLTHEXNUT

CARRIAGE

BOLT

I

L

LEG

STORAGELOWERBRACE

BRACKET(S)

WASHER

NUT

LEVELINGFOOT--_'_HEX

Figure 8

CRAFTSMAN"TABLESAW315.22811016