Niles Audio SI-2125 specifications Troubleshooting Guide

Page 17

TROUBLESHOOTING GUIDE

TROUBLESHOOTING GUIDE (continued)

SYMPTOM

POSSIBLE CAUSES AND TEST PROCEDURE

Hum from the speakers

Check for faulty cables, faulty source material, an

 

ungrounded phono system or a defective component.

Amp will not turn on

AC power cord must be plugged into a working outlet.

 

Master power switch must be on.

Bass sound is weak and

The loudspeakers are wired out of phase.

the stereo image is

Reverse the connections at the back of one speaker.

“phasey” or “blurry”

Make sure that the Bridge Mode Switch is in the

sounding in one room

stereo position if the amplifier is being used in a

 

stereo configuration.

17

Image 17
Contents Congratulations Introduction Features and Benefits Bridged Mode Status Display for TroubleshootingTurn-On Modes Automatic ProtectionPlacement Installation ConsiderationsInstallation Considerations Multiple Speaker Loads Tech TIPCable and Wire InstallationFront and Rear Panel Details IEC receptacle for AC power cord Setting the Turn-On Mode Switch InstallationBare Wire Speaker Wire ConnectionsCascade Audio Outputs Line Level Audio Input Supplied AC cord into the IEC AC Power PlugOperation Symptom Possible Causes and Test Procedure Troubleshooting GuideTroubleshooting Guide Specifications Niles Audio Corporation SI-2125
Related manuals
Manual 20 pages 20.26 Kb Manual 20 pages 57.48 Kb