Onkyo DR-815 instruction manual Connecting the Power Cord, First Time Setup, Turning Off Accuclock

Connecting the Power Cord

	When the power cord is connected to the AC outlet, the
To wall outlet	DVD receiver enters Standby mode. The STANDBY
	indicator lights up.
	When you want to set the clock using the DVD receiver’s
	ACCUCLOCK function, the FM antenna needs to be
	connected for receiving the RDS radio broadcasts. For
	more information, see page 16.

STANDBY indicator

First Time Setup

The very first time you turn on the DVD receiver, the ACCUCLOCK function automatically sets the clock by using the CT (Clock Time) information present in RDS radio broadcasts. While the clock is being set, “Wait” flashes on the display, as shown. It may take up to five minutes to set the clock.

When the clock has been set, the message “Clock Adjusted” scrolls across the display, then the day and time are dis- played for a while, as shown.

The ACCUCLOCK function automatically updates the clock daily at 2 A.M., 3 A.M. and 2 P.M.

If the clock has not been set correctly, see “Setting ACCUCLOCK to Use a Specific Station” on page 58 and “Setting the Clock Manually” on page 59.

Turning Off ACCUCLOCK

If you don’t want ACCUCLOCK to automatically update the clock at 2 A.M., 3 A.M. and 2 P.M. everyday, you can turn it off as follows.

1

2

Press TIMER button repeatedly until “Clock” appears on the dis- play, as shown.

Press MULTI JOG.

“*AccuClock*” appears on the display, as shown.

These asterisks appear when the ACCUCLOCK function is on.

3	To turn off ACCUCLOCK, press
	YES/MODE.

The asterisks disappear, indicating that the ACCUCLOCK function is off. To turn the ACCUCLOCK function on again, press YES/MODE so that aster- isks appear.

Note:

This operation is not available if time adjustment was not properly performed in the previous section.

25