Onkyo DR-815 instruction manual Adjusting Sound, Audio Adjust Function

Adjusting Sound—Continued

1, 4 2, 3

Audio Adjust Function

By using the following audio adjust function, you can fine adjust the tone and the precise settings for Mono, Multiplex and T-D.

1	Press RCV SETUP.
	The display will show “1.Sp Config”.

2	Press / (repeatedly) to select
	“4.Audio Adj”.

And then press ENTER.

3	Select an item you want to configure
	using / , and select a value or a
	preference using	/ .

4	Press RCV SETUP.
	That exits the setting.
	To return to a higher step, press
	RETURN.

The Audio Adjust functions are explained below.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps. You can set a value when the listening mode is set to other than “Direct”.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps. You can set a value when the listening mode is set to other than “Direct”.

■Mono (2ch)

This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or 2- channel analog/PCM source in the Mono listening mode.

LR: Both the left and right channels are output (default).

L:Only the left channel is output.

R:Only the right channel is output.

■Multiplex

This setting determines which channel is output from a stereo multiplex source. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

M:The main channel is output (default).

S:The sub channel is output.

MS: Both the main and sub channels are output.

■LstnAngl (Listening Angle)

Select this to modify the Theater-Dimensional (T-D) lis- tening modes.

The listening angle is the angle subtended by the front left and right speakers as seen from the listener. The pro- cessing for the virtual surround will be based on this angle. The setting of 20, 30 and 40 degrees are only for nominal purposes, so select the setting that is closest to your actual listening angle.

Front left speaker	Front right speaker
	Listening angle

■T-D mode

This is a setting for 5ch speaker composition with “T-D” (Theater-Dimensional) selected.

You can take advantage of the feature in the case where you have to place the surround speakers in front because of the restricted space availability or for other reason.

ALL: Select this setting when you use surround speak- ers but they can not be placed in the right place.

FRT: Select this setting in other cases than above.

57