Onkyo DR-815 instruction manual Naming Preset Channels, Naming a Preset Channel, Entering a Name

Naming Preset Channels

You can name FM/AM preset channels.

Naming a Preset Channel

After you select the preset channel to name, execute

“Entering a Name” as described below. You can enter up to eight characters per name.

Display

2, 4

1

3 5

Entering a Name

1	Press EDIT/NO/CLEAR and turn
	MULTI JOG until “Name In?”
	appears in the display.

2 Press MULTI JOG.

3	Press DISPLAY repeatedly until
	the character type you wish to
	enter appears in the display.

You can select one of the following char- acter entry modes:

•“A” for capital letters

•“a” for small letters

•“1” for numbers and symbols

The character type appears.

4	Turn MULTI JOG to select the char-
	acter, then press it to enter.
	Repeat this step for the next character. If
	you wish to change the type of charac-
	ters, repeat Step 3, then proceed with this
	step.
	To cancel the entering name, press and
	hold EDIT/NO/CLEAR for more than
	two seconds.
5	Press YES/MODE after you enter
	all the characters.
	You will see the “Complete” message
	that indicates the entry of characters is
	completed.

What Characters Can Be Entered?

You can enter the following characters:

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z

0 1 2 3 4 5 6 7 8 9

_ @	' < > # $ % & * = ; : + - / ( ) ?
! ’ ”	, .	(space)	(insert)

Correcting and Erasing a Character

If the unit is not in “Name In” mode, execute Steps 1 and 2 in “Entering a Name,” then follow the steps below.

1 Press / repeatedly until the character you wish to correct or erase flashes.

2When correcting

Enter the desired character following Steps 3 and 4 in “Entering a Name” in the left column.

When erasing

Press EDIT/NO/CLEAR on the unit or CLEAR on the remote controller.

Notes:

•If you press and hold EDIT/NO/CLEAR for more than two seconds, the DVD receiver returns to the pre- vious indication without erasing characters.

•To continue entering characters, execute Step 3 in the left column. To complete the operation, execute Step 5.

50