Connecting Speakers

Getting Connected cont.

The Speaker Terminals are located on the rear panel. There are two SPEAKER terminals. Be sure to connect the left channel (L), right channel (R), “+” (red) and “--” (black) properly.

��

Preparing the Speaker Cable

You can either use an exposed speaker wire or Banana Plug speaker cable.

Exposed Speaker Wire

1. Remove approximately 3/8” (10mm) of insulation

��

2. Twist the exposed wires together to prevent short circuits

•Before connecting the speakers, make sure that the CDG- 6000RV is disconnected from the power source.

•Do not let the bare speaker wires touch each other or another metal part of this unit. This could damage the CDG-6000RV and/or the speakers.

Determining the proper way to connect the speaker cables:

The speaker cable is a pair of insulated cables running side by side. One cable is colored or shaped differently , perhaps with a stripe, groove or ridges.

1.Connect one end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the rear panel of the CDG-6000RV.

2.Connect the other end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the speaker.

3.Connect one end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the rear panel of the CDG-6000RV.

4.Connect the other end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the speaker

��

4.Insert the bare wire

5.Tighten the knob until the wire is secure

��