SpeakerCraft BassX-W10 owner manual Specifications BBXW10 Amplifier

Page 11

BassX-W10 Owner’s Manual

Page 11

SPECIFICATIONS – BBXW10 Amplifier

Type:

Mono Class A-B dedicated subwoofer amplifier

Power Output:

250 watts per channel

Crossovers:

Variable Low Pass Crossover 35Hz to 150 Hz, Fixed High Pass Crossover at 75Hz

THD @ 10 Watts:

0.1%

Input Sensitivity:

8.6 mv

Input Impedance:

33 kOhms

Auto Off Time:

> 15 minutes

Auto On Sensitivity:

2.5 mv

Signal to noise ratio:

> 70dB

Dimensions:

H 338" x W 17" x D 1112" (add 34" for feet & 4" for rear panel connectors)

Weight:

16 lbs.

LIMITED LIFETIME WARRANTY – BassX-W10 Subwoofer

SpeakerCraft Inc. warrants to the original retail purchaser only that the BassX-W10 Subwoofer will be free from defects in materi- als and workmanship, provided the speaker was purchased from a SpeakerCraft Authorized Dealer.

Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were purchased, or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is preferable to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the risk or loss or damage in transit is to be borne by the purchaser. If, upon examina- tion at the Factory or SpeakerCraft Authorized Dealer, it is determined that the unit was defective in materials or workmanship at any time during this warranty period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair or replace this product at no additional charge, except as set forth below. If this model is no longer available and can not be repaired effective- ly, SpeakerCraft, at its sole option, may replace the unit with a current model of equal or greater value. In some cases where a new model is substituted, a modification to the mounting surface may be required. If mounting surface modification is required, SpeakerCraft assumes no responsibility or liability for such modification. All replaced parts and product become the property of SpeakerCraft Inc. Products replaced or repaired under this warranty will be returned to the original retail purchaser, within a rea- sonable time, freight prepaid.

This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inad- equate packing or shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the product which has not been authorized or approved by SpeakerCraft. This warranty also excludes normal cosmetic deterioration caused by environmental conditions. This warranty will be void if the serial number on the prod- uct has been removed, tampered with or defaced.

This warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted above, the purchaser’s sole remedy shall be repair or replacement as provided above. In no event will SpeakerCraft be liable for any inci- dental or consequential damages arising out of the use or inability to use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply.

All implied warranties on the product are limited to the duration of this expressed warranty. Some states do not allow limitation on the length of an implied Warranty. If the original retail purchaser resides in such a state, this limitation does not apply.

LIMITED TWO YEAR WARRANTY – BBXW10 Amplifier

SpeakerCraft Inc. warrants to the original retail purchaser only that the SpeakerCraft BBXW10 Amplifier will be free from defects in materials and workmanship for a period of two years, provided the product was purchased from a SpeakerCraft Authorized Dealer.

Image 11
Contents BassX-W10 Safety Instructions System Description Installation Overview DiagramSystem Design Considerations InstallationSystem Components Installation and Operation of the BBXW10 Amplifier Installation of BBXW10 BBXW10 Front Panel Active LED Volume Control Amplifier Operation Problem TroubleshootingSpecifications BBXW10 Amplifier SpeakerCraft