Sharp CP-SW1000H General control, Test of the remote control, To turn the power on, Position a

Page 7

CP-SW1000H

ENGLISH

Remote control (continued)

Notes concerning use:

Replace the battery if the operating distance is reduced or if the operation becomes erratic. Purchase “CR 2025”, coin lithium battery.

Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

Keep the remote control away from moisture, heat, shock, and vibrations.

Test of the remote control

General control

Preparation for Use

Point the remote control directly at the remote sensor on the unit.

The remote control can be used within the range shown below:

Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your system.

Position A

Position B

Remote sensor

Remote sensor

To turn the power on

Press the ON/STAND-BY button.

The volume indicator lights up blue.

If the power does not turn on, check whether the power lead is plugged in properly.

(Lights up blue)

To set the unit to stand-by mode:

Press the ON/STAND-BY button

0.2m - 6 m

(8” - 20’)

15˚

15˚

0.2 m - 6 m

(8” - 20’)

15˚ 15˚

again.

 

The STAND-BY indicator lights up

(Turns red)

red.

 

E-7

Image 7
Contents Introduction FeaturesContents AccessoriesCooling fan PrecautionsVolume control GeneralRear panel Controls and indicatorsRemote control Front panelPlacing the subwoofer Subwoofer preparationMagnetically shielded speakers Tuner receiving for other audio system Connecting to a TVConnecting to a TV with subwoofer pre-out Subwoofer connections to TVsPrecautions for battery use AC power connectionRemote control Battery installationPosition a Test of the remote controlTo turn the power on General controlWatching TV Operating the TV with the remote controlAuto power off Crossover frequency controlIf such a problem occurs, do the following Troubleshooting chartIf problem occurs Symptom Possible causeSpecifications MaintenanceCleaning the cabinet