Sharp CP-SW1000H Troubleshooting chart, Condensation, If problem occurs, Symptom Possible cause

Page 9

CP-SW1000H

Troubleshooting chart

ENGLISH

References

Many potential problems can be resolved by the owner without calling a service technician.

If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.

General

Symptom

Possible cause

 

 

No sound is heard.

Is the input signal (selection) set

 

properly?

 

Is the volume level set to “0”?

 

 

Noise is heard during

Move the subwoofer away from any

playback.

computers or mobile phones.

 

 

When a button is

Set this unit to the stand-by mode and

pressed, the unit

then turn it back on.

does not respond.

 

 

 

The power is not

Is the unit unplugged? (Refer to page 6)

turned on.

The protection circuit may be activated.

 

Unplug and plug in the power lead again

 

after 5 minutes or more.

 

 

Condensation

Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet. Condensation can cause the unit to malfunction. If this happens, leave the power on until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter with a soft cloth before operating the unit.

If problem occurs

When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is operated incorrectly, it may malfunction.

If such a problem occurs, do the following:

1.Set the unit to the stand-by mode and turn the power on again.

2.If the unit is not restored in the previous operation, unplug and plug in the subwoofer, and then turn the power on.

E-9

Remote control

Symptom

Possible cause

 

 

The remote control

Is the battery polarity correct?

does not operate

Is the battery dead?

properly.

Is the distance or angle incorrect?

 

Are there any obstructions in front of the

 

subwoofer?

 

Is there a strong light shining on the

 

remote sensor?

 

Is the remote control for another

 

equipment used simultaneously?

 

 

The subwoofer cannot

Is the AC power lead of the subwoofer

be turned on with the

plugged in?

remote control.

Is the battery inserted?

TV cannot be

Depending on the model, some or all

operated with the

functions may not be operable using the

remote control.

remote control of this unit. In this case,

 

use the remote control supplied with the

 

TV.

 

 

Image 9
Contents Contents FeaturesAccessories IntroductionVolume control PrecautionsGeneral Cooling fanRemote control Controls and indicatorsFront panel Rear panelSubwoofer preparation Placing the subwooferMagnetically shielded speakers Connecting to a TV with subwoofer pre-out Connecting to a TVSubwoofer connections to TVs Tuner receiving for other audio systemRemote control AC power connectionBattery installation Precautions for battery useTo turn the power on Test of the remote controlGeneral control Position aAuto power off Operating the TV with the remote controlCrossover frequency control Watching TVIf problem occurs Troubleshooting chartSymptom Possible cause If such a problem occurs, do the followingMaintenance SpecificationsCleaning the cabinet