Maintenance and Troubleshooting | GBC F-36 instruction

Maintenance and Troubleshooting	F-36 PRO Laminator Operation Manual

	Use Your
Provide	Other Hand to
Provide	Gently Bend
Support
At Rivets

Figure 4-1: Adjusting the Thermocouple

Once installed, the critical point of the thermocouple

MUST make direct contact with the roll as shown in

Figure 4-2.

Bend

Rivets

Thermal

Junction

Roll

Figure 4-2: Correct Thermocouple Contact

CAUTION

Firmly hold the thermocouple where the “guitar

pick” sensor is riveted to the aluminum base while bending. You can break the sensor off the base if you do not provide this added support.

5.Replace the thermocouple and tighten the screws.

6.Repeat the procedure for the other thermocouple.

4-2	© GBC Pro-Tech 1999 January

Image 36

GBC F-36 manual Maintenance and Troubleshooting, Firmly hold the thermocouple where the guitar

Contents

GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop Buttons GBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning Position the jumpers as shown in -6 for Service choice ! # + Installation Laminator Space Requirements +$ Tools requiredIf the laminator is in a cardboard box Foot Bolt Shipping Pad If the laminator is in a crate Removing the Crate Setup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# $ # Then mounted $ Insert a starter board into the nip and lower # #- Identification Diagram 34*/534*6!575 34*/5 34*6!575One-Pass Mounting and Laminating 34*/5 34*6!575One-Pass Mounting 34*/55 34*6!5755Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/58 34*6!5758Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5%5 34*6!575%5Two Pass Mount and Hot Overlaminate, First Pass 34*/5%8 34*6!575%8Two Pass Mount and Hot Overlaminate, Second Pass 34*/5 34*6!575Encapsulation #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitar Upper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rolls To clean the cabinet and covers 9$# 4 To adjust the chain tension # $ $ # #$7 This warranty specifically does not cover Unauthorized customer alterations will void this Warranty. & Warranty Part Description Recommended Quantity Specifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index