GBC F-36 manual  +$, Tools required, If the laminator is in a cardboard box

F-36 PRO Laminator Operation Manual Installation

, +$

☞NOTE

ALL SHIPMENTS ARE EX- WORKS. At our dock, title passes to the buyer. Please review your insurance cov- erage prior to shipment, as you are responsible for all subsequent freight charges and risks. Before signing the Bill of Lading, be sure to inspect the crate and/or pallet for signs of damage or missing items; if applica- ble, make a note of this on the Bill of Lading.

The F-36 PRO Laminator is shipped one of two ways. It is either encased in a wood crate on a skid or in a cardboard box on a skid.

WARNING

The unpacking process requires at least two people. You can be severely injured or crushed.

Tools required:

•Phillips head screwdriver

•7/8" open end wrench or adjustable wrench

If the laminator is in a cardboard box:

1.Remove the securing screws around the bottom of the box using the Phillips head screwdriver as shown in Figure 2-2.

Figure 2-2: Removing the Cardboard Box

2.Lift the cardboard box off the laminator.

3.Gently unwrap the shrink wrap from around the laminator.

CAUTION

Do not use a knife or other sharp instrument

during installation or while servicing the

laminator. You can cause irreparable damage to

the rolls.

4.Carefully remove any accessories packed with the laminator. The accessory pack should contain:

1 Set, hex wrenches

1 Slitting knife

1 Manual

1 Set, spare fuses

1 Tape measure

1 Roll of masking tape

1 Rubber cement eraser

© GBC Pro-Tech 1999 January 2-3