34*/5%8, 34*6!575%8 | GBC F-36

F-36 PRO Laminator Operation Manual	Operation

34*/5%8

Two Pass Mount and Hot Overlaminate, Second Pass

MATERIALS

Upper Media	N/A		Image Media	N/A

Lower Media	N/A		Mounting Substrate	Foam Core

		LAMINATOR SETTINGS

Top Heater Status	OFF		Drive Mode	Manual (Footswitch)

Bottom Heater Status	OFF		Pull Roll Position	DOWN

Speed	2-3 ft/min		Output Cooling	OFF

Drive Direction	REV		Main Roll Setting	UP

34*6!575%8

CAUTION: Do not allow foam board to drop below Fan Bridge Lip

Encapsulated Image

Release Liner

Foam Core

Notes

__________________________________________________________________________________________

__________________________________________________________________________________________

__________________________________________________________________________________________

© GBC Pro-Tech 1999 January

3-15

Image 33

GBC F-36 manual 34*/5%8, 34*6!575%8, Two Pass Mount and Hot Overlaminate, Second Pass

Contents

GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Using the Emergency Stop Buttons Safety GBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning Position the jumpers as shown in -6 for Service choice ! # + Laminator Space Requirements Installation +$ Tools requiredIf the laminator is in a cardboard box Foot Bolt Shipping Pad Removing the Crate If the laminator is in a crate Setup Procedure Power Cord Connection Startup Checklist Operation $# -# $# $ $ # $ Then mounted Insert a starter board into the nip and lower # #- Identification Diagram 34*/534*6!575 34*/5 34*6!575One-Pass Mounting and Laminating 34*/5 34*6!575One-Pass Mounting 34*/55 34*6!5755Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/58 34*6!5758Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5%5 34*6!575%5Two Pass Mount and Hot Overlaminate, First Pass 34*/5%8 34*6!575%8Two Pass Mount and Hot Overlaminate, Second Pass 34*/5 34*6!575Encapsulation #$ Firmly hold the thermocouple where the guitar Maintenance and Troubleshooting Upper Main To clean beads of adhesive, dust and dirt from the rolls To clean the laminator rolls 9$# 4 To clean the cabinet and covers # $ To adjust the chain tension $ # #$7 This warranty specifically does not cover Unauthorized customer alterations will void this Warranty. & Warranty Quantity Part Description Recommended Specifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index