#$7 | GBC F-36 specification

Maintenance and Troubleshooting	F-36 PRO Laminator Operation Manual

#$7

Problem:

D waves in the image, not in the laminate.

Hints:

•Check paper tension.

•Check relative moisture content of the paper.

Problem:

Waves on only one side of the output.

Hints:

•Check nip settings.

•Check for even paper tension.

Problem:	Problem:
D waves in the laminate.	Straight waves in the output.
Hints:	Hints:
• Increase clutch tension.	• Decrease clutch tension.
• Check roll pressures.	• Check operational settings for
• Check nip settings.	materials being used.

Other Common Problems:

Feed

DirectionProblem:

Blistering in the image.

Hints:

•Increase speed or lower the operating temperature.

Problem:

Coiling of encapsulated images.

Hints:

•Balance the upper and lower unwind brake tension. Make sure main roll temperatures are the same. Adjust cooling fans.

Problem:

Longitudinal waves or stuttering, jerking, or excessive noise from the drive side of the laminator.

Hints:

•Increase chain tension, decrease unwind brake tension.

4-8	© GBC Pro-Tech 1999 January

Image 42

GBC F-36 manual #$7

Contents

GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop Buttons GBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning Position the jumpers as shown in -6 for Service choice ! # + Installation Laminator Space Requirements +$ Tools requiredIf the laminator is in a cardboard box Foot Bolt Shipping Pad If the laminator is in a crate Removing the Crate Setup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# $ # Then mounted $ Insert a starter board into the nip and lower # #- Identification Diagram 34*/534*6!575 34*/5 34*6!575One-Pass Mounting and Laminating 34*/5 34*6!575One-Pass Mounting 34*/55 34*6!5755Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/58 34*6!5758Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5%5 34*6!575%5Two Pass Mount and Hot Overlaminate, First Pass 34*/5%8 34*6!575%8Two Pass Mount and Hot Overlaminate, Second Pass 34*/5 34*6!575Encapsulation #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitar Upper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rolls To clean the cabinet and covers 9$# 4 To adjust the chain tension # $ $ # #$7 This warranty specifically does not cover Unauthorized customer alterations will void this Warranty. & Warranty Part Description Recommended Quantity Specifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index