, $ # | GBC F-36 instruction

F-36 PRO Laminator Operation Manual	Maintenance and Troubleshooting

*

Tools required:

•1/8" hex wrench

•High temperature grease or lithium grease

•Grease gun

To lubricate the laminator:

WARNING

Do not lubricate the laminator when it is hot. You

can be burned.

WARNING

Unplug the laminator and lockout power while you are performing this procedure. You could be severely shocked, electrocuted, or get your fingers caught in the drive mechanisms.

1.Remove the drive and control side cabinet covers using the 1/8" hex wrench by removing the six screws holding each cover in place.

2.Using the grease gun, lubricate each grease fitting (shown in Figure 4-7) with one squirt of high tem- perature grease.

Grease	WA
		RN
	SEEN GANG
	A		IN
	CH		TU	G
	MI		TU
Fittings				RDE
Fittings
	Mo
	cr vin
	us	gp
	Do handartsc
	do not		cut.an
	orooper
		pen.ate		with
				with

Figure 4-7: Grease Fittings

3.Lubricate the chain using a soft cloth and automo- tive oil.

4.Replace the cabinet covers and reconnect power to the laminator.

$ #

For machine parts and technical service in North America, please call: 1-800-790-7787. Please provide serial number when calling for service. In Europe, please call: +44 (0) 1844 202 440 or fax: +44 (0) 1844 202 441.

For film and application questions in North America, please call 1-800-236-8843. In Europe, please call: +44

(0) 1844 202 440 or fax: +44 (0) 1844 202 441.

© GBC Pro-Tech 1999 January

4-7

Image 41

GBC F-36 manual , $ #

Contents

GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Using the Emergency Stop Buttons Safety GBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning # + Position the jumpers as shown in -6 for Service choice ! Laminator Space Requirements Installation If the laminator is in a cardboard box +$Tools required Foot Bolt Shipping Pad Removing the Crate If the laminator is in a crate Setup Procedure Power Cord Connection Startup Checklist Operation $# -# $# $ # $ $ Then mounted Insert a starter board into the nip and lower # #- 34*6!575 Identification Diagram34*/5 One-Pass Mounting and Laminating 34*/534*6!575 One-Pass Mounting 34*/534*6!575 Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/5534*6!5755 Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5834*6!5758 Two Pass Mount and Hot Overlaminate, First Pass 34*/5%534*6!575%5 Two Pass Mount and Hot Overlaminate, Second Pass 34*/5%834*6!575%8 Encapsulation 34*/534*6!575 #$ Firmly hold the thermocouple where the guitar Maintenance and Troubleshooting Upper Main To clean beads of adhesive, dust and dirt from the rolls To clean the laminator rolls 9$# 4 To clean the cabinet and covers # $ To adjust the chain tension $ # #$7 . & This warranty specifically does not coverUnauthorized customer alterations will void this Warranty Warranty Quantity Part Description Recommended Specifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index