GBC F-36 manual  , Setup Procedure

Installation F-36 PRO Laminator Operation Manual

WARNING

Do not attempt to move the laminator across anything other than a flat, level surface without trained and qualified riggers. You can be crushed or seriously injured.

The F-36 PRO Laminator is a large and heavy piece of equipment. It is necessary to employ LICENSED RIGGERS ONLY to move the machine. The laminator is not designed to be tipped up or sideways in any way. Such action disturbs the exact alignment of the rolling parts of the machine and requires extensive realignment. GBC Pro-Tech’s warranty does not cover malfunction of the equipment due to mishandling and/or tipping.

GBC Pro-Tech bears no responsibility for personal injury or damage due to moving the laminator improperly.

6.Once the laminator is in place set the locking mechanism on all four wheels to ON.

7.Remove any plastic strapping and packing paper taped to the rolls.

CAUTION

Do not use a knife or other sharp instrument

during installation or while servicing the

laminator. You can cause irreparable damage to

the rolls.

8.Remove all packing materials to a safe distance from the laminator.

☞A NOTE ABOUT RECYCLING

The crate components can be reused for shipping the machine again, or can be disassembled and the wood and screws recycled. The shrink wrap is not recyclable, however, so it must be discarded.

☞NOTE

A word about international shipments: As these are heavy pieces of equipment, GBC Pro-Tech takes every precaution to ensure that our laminators are properly crated to the highest standards.

Before machines leave our loading dock, they are pre- treated with a VCI protective film to provide total cor- rosion protection. This protective film is wrapped around the machine and completely sealed. In addition, moisture absorbing silicone desiccite packs are packed inside the crate and machine cabinets.

Prior to start up of the machine, you must remove the desiccite packs from each cabinet and discard. DO NOT operate the machine with the desiccite packs inside the cabinets.

 

Once the F-36 PRO Laminator has been unpacked and moved into final position check each of the following items.

Tools required:

•1/8" hex wrench

•Adjustable wrench

Setup Procedure

1.Inspect the laminator for any obvious shipping damage.

2.Remove the drive and control side cabinet covers with the 1/8" hex wrench by removing the six screws holding each cover in place.

3.Inspect all the bolts and tighten any that were loos- ened during shipping.

4.Check the upper main roll assembly by using the handwheel to raise and lower the roll. It should move smoothly.

5.Set the nip. (See Section 4: Maintenance and Trou- bleshooting for the procedure.)

6.Verify that both sensors are clean and properly con- tact the rolls.

2-6 © GBC Pro-Tech 1999 January