34*/55, 34*6!5755 | GBC F-36

Operation	F-36 PRO Laminator Operation Manual

34*/5"5

Two Pass Mount and Cold/Pressure Overlaminate, First Pass

MATERIALS

Upper Media	Pro-Gloss	Image Media	Bond Paper

Lower Media	Pro-Mount	Mounting Substrate	N/A

	LAMINATOR SETTINGS

Top Heater Status	ON @ 110 ºF (43 ºC)	Drive Mode	Manual or Auto

Bottom Heater Status	OFF	Pull Roll Position	UP or DOWN

Speed	4-6 ft/min	Output Cooling	OFF

Drive Direction	FWD	Main Roll Setting	DOWN - 1/2 turn

34*6!575"5

Release

Liner Rewind

Release Liner

Notes

___________________________________________________________________________________________

___________________________________________________________________________________________

___________________________________________________________________________________________

3-12	© GBC Pro-Tech 1999 January

Image 30

GBC F-36 34*/55, 34*6!5755, Two Pass Mount and Cold/Pressure Overlaminate, First Pass

Contents

GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop Buttons GBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning Position the jumpers as shown in -6 for Service choice ! # + Installation Laminator Space Requirements +$ Tools requiredIf the laminator is in a cardboard box Foot Bolt Shipping Pad If the laminator is in a crate Removing the Crate Setup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# $ # Then mounted $ Insert a starter board into the nip and lower # #- Identification Diagram 34*/534*6!575 34*/5 34*6!575One-Pass Mounting and Laminating 34*/5 34*6!575One-Pass Mounting 34*/55 34*6!5755Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/58 34*6!5758Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5%5 34*6!575%5Two Pass Mount and Hot Overlaminate, First Pass 34*/5%8 34*6!575%8Two Pass Mount and Hot Overlaminate, Second Pass 34*/5 34*6!575Encapsulation #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitar Upper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rolls To clean the cabinet and covers 9$# 4 To adjust the chain tension # $ $ # #$7 This warranty specifically does not cover Unauthorized customer alterations will void this Warranty. & Warranty Part Description Recommended Quantity Specifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index