Sharp LC-60LE650LX, LC-70LE650LX Protection against overturning, Removing the stand, Anchoring

Protection against overturning

There is a danger of the product overturning in the case of a disaster or sudden collision. Carry out the following tip-resistant measurement for your safety.

Anchoring the
1 Affix the TV	strong
ties and cup

Cup hook (commercially available)

Tie (commercially available)

Fixing the TV to the table

1Place the TV on the table.

2Pull the attached restraining bracket out so that it is at a 90 degrees angle.

3Insert commercially available screws in the holes of the restraining bracket and tighten the screws to secure the TV to the table.

•Use commercially available screws to firmly secure the TV.

Stand

Screw (commercially available)

Restraining bracket (attached)

CAUTION

•As this product is heavy, use a table that is wide enough to support the product and capable of withstanding the product’s weight. The table should be set where it will not be overturned.

•Be sure to use at least two people when moving the TV.

Removing the stand

For wall mounting with the bracket remove the stand.

Before setting TV on the wall

•Remove the connected cables (DVD, VCR, etc) from the terminals.

•Detach the four caps at the 4 locations on the rear of the TV.

1Unfasten the screws at the 4 locations on the rear of the stand.

2Detach the stand from the TV (hold the stand so it will not drop from the edge of the base area).

NOTE

•To attach the stand, perform the above steps in reverse order.

•As the TV is very heavy, be careful when moving it.

31