Jensen MP6612i manual Tools and Supplies, Preparation, Mounting Sleeve Installation

Page 6

MP6612i

INSTALLATION

This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialty shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. If you have trouble locating a kit or need installation assistance, contact Technical Support at 1-800-323-4815 from 9:00am to 6:00pm EST Monday through Friday.

Tools and Supplies

The following tools and supplies are needed to install the radio:

Torx type, flathead and Philips screwdrivers

Wire cutters and strippers

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

Electrical tape

Crimping tool

Volt meter/test light

Crimp connections

18 gauge wire for power connections

16-18 gauge speaker wire

Preparation

1.Disconnect Battery

Before you begin, always disconnect the battery negative terminal.

NOTE: If the MP6612i is to be installed in a car equipped with an on- board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.

2.Remove Transport Screws

TRANSPORT

SCREWS

HALF

SLEEVE

3.Remove Radio from Sleeve

Lift latches on both sides of sleeve to remove half-sleeve from radio.

Mounting Sleeve Installation

1.Slide the mounting sleeve off the chassis. If it is locked into position, use the removal tools (supplied) to disengage it.

2.Check the dashboard opening size by sliding the mounting sleeve into it.

If the opening is too small, carefully cut or file as necessary until the sleeve easily slides into the opening. Do not force the sleeve into the opening or cause it to bend or bow. Check for sufficient space behind the dashboard for the radio chassis.

3.Locate the series of bend tabs along the top, bottom, and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard.

2

Image 6
Contents Page Page Table of Contents MP6612i Features IntroductionTools and Supplies InstallationMounting Sleeve Installation PreparationReconnect Battery Kit InstallationISO Installation FusesTechnical Assistance Wiring Memory/BatteryFront Panel Release Detaching the Front PanelRe-attaching the Front Panel Operation PowerVolume / Audio Control SourceLevel Mid-Range MIDSystem Menu Operation Clock SetReset Button Tuner Operation MP6612i CD Player Operation MP3/WMA Operation Loading an MP3/WMA Disc Bit RatesMP3 Playing Order Loading an SD CardMP3/WMA Search Accessing the ID3 TagNavigating Folders Track SearchCharacter Search Satellite Radio Operation Accessing Satellite Radio ModeDirect Tuning Mode Displaying the Identification ID CodeCategory Tuning Mode Display ModesAccessing iPod Mode Selecting a TrackIPod Category Search Pairing your Mobile Phone and Head Unit via Bluetooth Bluetooth OperationAbout Bluetooth Hands Free Profile HFPManaging Incoming Calls Connecting/Disconnecting Your PhoneUsing Speed Dial Making an Outgoing CallMenu List BT VolumeDialing a Saved Number Auto AnswerMP6612i Remote Control Replacing the BatteryOperating Range Care and Maintenance CD PlayerTroubleshooting Problem Cause Corrective ActionSpecifications Obtaining Warranty Service What is covered?What is not covered? CD or Multimedia Radios/HeadunitsPage