Jensen MP1311 owner manual Wiring, Fuses

Page 6

MP1311

WIRING

1. Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire.

2. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.

3.Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.

4.Memory/Battery (yellow wire) - Connect to

5

15

battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.

5.Antenna Connector - Connect the antenna plug from the existing antenna cable

(some vehicles require an adaptor).

 

6. Outputs to Amplifier (gray RCA cables) -

 

Connect line out for optional external

Gray

6

amplifiers. The red connector is for the

 

right and the white connector is for the left.

 

7.Left Front Speaker

8. Right Front Speaker

9. Left Rear Speaker

10. Right Rear Speaker

White/Black (-)

Dark Blue

Black

Yellow

+

Red

Gray/Black (-)

1

3

4

2

NOTE: The amplifiers in this radio are only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads

Fuses

When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MP1311 uses one 15 amp fuse located below the wiring connector (15 amp fast blow ATO).

7

White (+)

Green/Black (-)

9

Green (+)

8

Gray (+)

Violet/Black (-)

10

Violet (+)

to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.

6

Image 6
Contents MP1311 Preparation Installation Instructions Pre-installationUniversal Installation Using Mounting Sleeve Kit Installation ISO InstallationReconnect Battery Remove Radio Wiring FusesOperating Instructions PowerVolume ModeEqualizer Selector EQ Audio Mute MuteBeep Tone Liquid Crystal Display LCDFront Panel Release Reset ButtonDisplay D Auxiliary InputPreset Stations TuningScan Tuning Scan Tuner OperationMono/Stereo Selector Mono Automatically Store / Preset Scan AS/PSPreset Scan Local / Distance SelectorPlay/Pause CD Player OperationInsert CD Disc Scan SCNDisc Shuffle RDM CD Player Error CodesDisc Repeat RPT Disc EjectAcceptable Media MP3/WMA Encoder and CD Writer SettingsMP3/WMA Operation Acceptable Disc FormatsElectronic Shock Protection Entering ID3 TagWriting Files into a Disc Bit RatesIntro Scan SCN PauseNavigating Folders Repeat RPTRoot Directory Search Display InformationDirectory/File Search Current Directory SearchRemote Control MO = MonoCompact Discs Care and MaintenanceCD Player CD-R and CD-RW CapabilityTroubleshooting Problem Cause Corrective ActionSpecifications Limited Warranty