Jensen owner manual CD3720XM Preparation, Wiring, Install Half-Sleeve

CD3720XM

Preparation (continued)

Install Half-Sleeve

1.Install adapter if necessary (optional).

2.Install half-sleeve into adapter or dashboard.

3.Push tabs out to secure half-sleeve in the radio opening.

4.Install support strap (provided) to make unit more stable.

Wiring

Wiring with a Wiring Adapter (Purchased Separately)

Connect Wires

You can make all of these connections without even being in the vehicle.

1.Splice or crimp wires.

2.Attach wiring adapter to car wiring harness.

Wiring Diagram / Color Codes

1.Auxiliary input (yellow RCA)

2.Antenna

3.Power Antenna (dark blue wire) – Connect to power antenna or amplifier. (If not used, tape bare end of wire.)

4.Ground (black wire) – Connect to ground terminal or clean, unpainted part of chassis.

5.Memory/Battery (yellow wire) – Connect to battery or 12 volt power source that is always alive. The radio will not work if this wire is not connected.

6.Accessory/Ignition (red wire) – Connect to existing radio wire or radio fuse.

7.Left front speaker

8.Right front speaker

9.Left rear speaker

10.Right rear speaker

11.Rear RCA pre-amp out (gray RCA)

12.XM® Direct Connect Cable

13.XM® Audio Input (black RCA)

*Cables sold separately.

**XM® Direct Tuner and antenna sold separately.

Install Half-Sleeve			Connect Wires
Instalación de la Camisa			Conecte los Cables
Installation du Demi-manchon			Raccordement des Fils
			Jensen Connector
	4
3
			1
		1
			2
2
			10A
13		12	1
2
*			3
Wiring	Rear		4
Cableado		Gray
	Posterior		+
Câblage	Arrière	Gris / Gris
			5
		11
**			6
		White/Black (-)	Gray/Black (-)
		Blanco/Negro (-)
			Gris / Negro (-)
		Blanc/Noir (-)
			Gris / Noir (-)
	7		8
		White / Blanco / Blanc (+)	Gray / Gris / Gris (+)
		Green/Black (-)	Violet/Black (-)
		Verde/Negro (-)	Violeta/Negro (-)
		Vert/Noir (-)	Violet/Noir (-)
	9		10
		Green / Verde / Vert (+)	Violet / Violeta / Violet (+)

3