Jensen XA4200, XA4300 warranty Indicators and Controls, Crossover X-OVER, Power / Protect Light

®

XA4200, XA4300

Indicators and Controls

LPF
FULL	BASS		L-CH X	R-CH X	LEVEL
HPF
X-OVER
FRONT
REAR
LPF	0dB	12dB	40Hz 400Hz	40Hz 400Hz	MIN	MAX
FULL	BASS		L-CH X	R-CH X	LEVEL
HPF
X-OVER
	0dB	12dB	40Hz 400Hz	40Hz 400Hz	MIN	MAX

POWER/ PROTECT

2CH

3CH

4CH

Crossover (X-OVER)

Adjust the crossover to accommodate your					Tri-mode/Three channel operation
chosen installation method.					An amplifier is usually configured for tri-mode
			•	LPF–(low pass filter) Select	operation when you want to use one amplifier to
					drive a pair of front speakers and subwoofer(s).
				this filter when the amplifier will
		LPF			In other words, when you want drive a complete
				be driving woofers or
		FULL			system with one amp. Your Jensen amplifier is
				subwoofers.
		HPF			capable of tri-mode operation.
			•	FULL–Crossover is not active,
	X-OVER				Important
	FRONT			amplifier is in “full range”
	REAR				Tri-mode operation requires using “passive
				mode.
		LPF			crossovers”. These crossovers are available at
		FULL	•	HPF–(high pass filter) Select	your local retailer or install shop. Failure to
		HPF
	X-OVER			this filter when the amplifier will	install these filters may damage your amplifier
				be driving full range/separate	and/or your speakers.
				speakers, and you want to limit
				the “bass” going to these
				speakers.

Power / Protect Light

POWER/ PROTECT

A dual status LED indicator illuminates red or green to indicate the status of the amplifier.

Green – Power applied, ON

Red – Protection circuit activated, STANDBY

10

5910 XA4CH_E.p65 10 01/23/01, 12:24 PM