JL Audio SB-SC-TC/10W3v3 warranty E P 1, Lay the Stealthbox back to it’s original position

S T E P 4

Place the spare tire onto the Stealthbox®, with the yellow side up.

Position the spare tire and Stealthbox® so the spare tire is matches up with the curve of the rear sill plate.

S T E P 5

Position the spare tire and Stealthbox® so the spare tire matches up with the curve of the left side foam panel.

S T E P 6

Make sure that the front L-bracket’s mounting hole is positioned over the hole from the removed grommet.

S T E P 7

Remove the spare tire without disturbing the Stealthbox®.

Remove the rear sill plate from vehicle.

SB-SC-TC/10W3v3_INSTR_SKU#01124

S T E P 8

Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring or anything else that might cause a reduction in your weekly pay.

Always wear eye protection when drilling!

With a drill and a 3/8-inch drill bit, using the rear L-bracket’s mounting hole as a guide. Drill through the vehicle’s wheel well.

S T E P 9

Lay the Stealthbox® onto it’s top side.

Run speaker wire from the amplifier location to the Stealthbox® location, apply spade forks onto the speaker wire, secure to the terminal and check for proper operation of the woofer.

S T E P 1 0

Lay the Stealthbox® back to it’s original position.

Apply a supplied flat washer onto a supplied hex cap screw.

Insert this bolt assembly through the rear Z-bracket and the drilled hole.

S T E P 1 1

Apply a supplied flat washer onto a supplied hex cap screw.

Drop this bolt assembly through the front L-bracket and large factory hole.

Page 2 • JL Audio, Inc 2006 Continued on Next Page