JL Audio SB-P-CYNNE/10W6v2/BK warranty E P 2, Make sure the ignition is not turned on

S T E P 2 0

With a T-25 socket, remove three bolts that secures this rear side trim panel.

S T E P 2 1

Pull the rest of the side trim panel from the body of the vehicle.

Once the side trim panel is loose, disconnect the power outlet 12V plug from the wire harness.

S T E P 2 2

Pull the side trim panel out of vehicle.

S T E P 2 3

With a T-30 socket, remove the bolts that secure the pocket to the body of the vehicle.

SB-P-CYNNE/10W6v2/BK_INSTR_SKU#011231

S T E P 2 4

Found in the rearmost driver’s side floor corner, remove the rubber grommet in the cargo area.

Unsecure the wire harness from the wheel well.

*Make sure the ignition is not turned on*

Loosen the bolt that secures the brown wires to the flooring of the vehicle.

Once loose, turn this wire assembly counter clockwise until the wires are routed as illustrated in the picture. Secure the bolt.

S T E P 2 5

Place the supplied top mount plate into position. The plate will only fit one way. The hole in the mounting plate will line up with the access hole from the removed grommet.

S T E P 2 6

Run speaker wire from the amplifier’s location to the Stealthbox® location and check for proper operation of the woofer.

S T E P 2 7

Thread in one of the supplied socket cup set screws into the bottom of the Stealthbox®, leaving 1-inch exposed.

Page 4 • JL Audio, Inc 2007 Continued on Next Page