JL Audio SB-J-GCHER3/10W1v2 warranty Remove any contents from the cargo area

SB-J-GCHER3/10W1v2_INSTR_SKU#011235

I N S T A L L A T I O N G U I D E

for the

SB-J-GCHER3/10W1v2

2005 - Up Jeep Grand Cherokee

If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox® be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems:

1)The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

INSTALLATION D I F F I C U LT Y :

2OUT

5OF

ESTIMATED TIME:

1-2 HOURS

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

S T E P 1

Remove any contents from the cargo area.

S T E P 2

With a Phillips screw driver, remove the woofer from the Stealthbox®.

Place the Stealthbox® onto the right side wheel well/side panel (mounting location).

With a pencil or marker, mark the location of the mounting hole onto the side panel from inside the Stealthbox®.

S T E P 3

Remove the Stealthbox® from the vehicle.

With an 3/8” drill bit and drill, drill a hole through the side plastic panel at the marked location from STEP 2.

There is a metal side panel that is located about 4” behind this plastic side panel. The metal side panel also needs to be drilled with the 3/8” drill bit. If the drill bit being used is more then 4” long, then once you’re through the plastic panel you can then mark or drill through the metal panel.

If your drill bit is not long enough. Mark onto the metal panel with a pencil or marker, through the hole that was drilled through the plastic panel.

Continued on Next Page