S T E P 2 8
With a Phillips head screw driver, secure the screw that was remove in STEP 9.
The
S T E P 2 9
Secure the c-pillar cover back into place.
With a Phillips head screw driver, secure the screw and the little cover that was removed in STEP 7.
S T E P 3 0
With a Phillips head screw driver, secure the screw that was removed in STEP 9.
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
|
| ||
I N C L U D E D H A R D W A R E |
|
| |
(1) | (1) | ||
(2) | Rod Coupling Nut | (1) | |
(2) | (2) |
(2)
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 10W1v2
Nominal Impedance: 4 ohms mono
Continuous Power Handling: 150 Watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio A2150.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the A2150 when being used to power your Stealthbox®.
The JL Audio A2150 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
Fits JL Audio Models:
Front Speaker Size / Location:
Fits JL Audio Models:
Rear Speaker Size / Location:
Fits JL Audio Models:
*Spacers required for proper speaker installation.
(954) | www.jlaudio.com |
|
|
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
Page 5 • JL Audio, Inc 2007
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A