JL Audio SB-GM-TRLBLZR/10W3v3/GA, SB-GM-TRLBLZR/10W3v3/DG, SB-GM-TRLBLZR/10W3v3/TN Inches

7-inches

S T E P 1 2

Use a hand held rotary tool (Dremel®) with cutting bit, to cut out the side panel for the compressor switch panel.

Remember the hole for the hose nozzle.

S T E P 1 3

Place one of the supplied wax squares, so the side of the wax square is flush against the plastic side panel and the middle of the wax square measures 7-inches from the front protrusion of the side plastic panel.

Not pictured. Place the second supplied wax square, so the side of the wax square is flush against the plastic side panel and the middle of the wax square measures 7-inches from the rear of the wheel well to the back of the SUV.

SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184

S T E P 1 6

Run speaker wire from the amplifier location to the Stealthbox® location and check for proper operation of the woofer.

S T E P 1 7

Back out the socket cup set screws so 1 1/4-inch of threads are exposed.

Place the Stealthbox® into position by guiding the socket cup set screws through the holes drilled.

S T E P 1 4

Thread the supplied pair of socket cup set screws into the bottom of the Stealthbox®, leaving 1/2-inch of thread exposed. Position the Stealthbox® in the mounting location and press down on it firmly.

Remove the Stealthbox® carefully, leaving the wax squares in place. The socket cup set screws will leave impressions in the wax.

S T E P 1 5

Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case (4x4 vehicles)

or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling!

With a drill and a 1/2-inch drill bit, drill through the impression made in the wax square and into the vehicle’s wheel well.

Remove the wax squares.

STEALTHBOX WALL	THREADED INSERT
SILCONE SEALANT	VEHICLE SHEET METAL
	FENDER WASHER
FLAT WASHER	SOCKET CUP SET SCREW
LOCK WASHER
HEX NUT

S T E P 1 8

From under the vehicle, place the supplied fender washers, flat washers, lock washers and then hex nuts onto each protruding socket cup set screw and secure. Adjust the amount of exposed thread on each cup set screw if necessary keeping in mind that leaving too much exposed tread will prevent the re-installation of the air compressor and or the plastic wheel well liner.

Note: For added protection, it is recommended that you apply a bead of silicone between the vehicle and the fender washer. After the bolt assembly is tightly secured, it is also recommended that vehicle under- coating material is applied to the exposed assembly.

If your SUV does not have the factory air compressor, please go directly to STEP 20.

SUVs with the air compressor only.

S T E P 1 9

Mount the air compressor back into position.

Page 2 • JL Audio, Inc 2005 Continued on Next Page