OSD Lang, TV Type | Lanzar Car Audio SD82 manual

1.11 INSTALLATION

INSTALLATION INSTRUCTIONS

IT IS AN ANTI-THEFT INSTALLATION WAY. THE CHASSIS WEAR A METAL

SLIDING HOUSING. PLEASE HAVE THE WIRING CONNECTION OF THE

POWER SUPPLY, SPEAKERS AND ANTENNA AS FOR THE REQUIREMENT

OF THE MANUAL, THEN INSTALL THE METAL SLIDING HOUSING INTO THE

CAR ACCORDING TO THE DIAGRAM.

	TO BOOST UP THE CAPABILITY OF
	ANTI-JAMMING, PLEASE FIX THE	SELECT THE PROPER FIXER
	METAL STRAP ON THE METAL	SELECT THE PROPER FIXER
	METAL STRAP ON THE METAL	FOR FIXING THE SLIDING
	CONNECTED TO THE BOTTO M	FOR FIXING THE SLIDING
METAL STRAP	CONNECTED TO THE BOTTO M	METAL HOUSING.
	BRACKET OF THE CAR.	METAL HOUSING.
	BRACKET OF THE CAR.

UNIT CHASSIS

PLASTIC TRIM OUT

5.19 System Setup Menu Operation

1.Press SETUP button on the IR remote control to display System Settings Main Menu on the TV screen. The System Setting Main Menu consist of 4 parts, i.e. 4 sub-menu. From left side to right side, they are General Setup Page, Speaker Setup Page, Video Setup Page and Preference Page.

2.Use LEFT/RIGHT button to select one of the above 4 parts. Then press ENTER or PLAY/PAUSE button to enter it.

3.Use LEFT/RIGHT/UP/DOWN button to select a item you want set, then press ENTER or PLAY/PAUSE button to conform it.

4.After finishing setting, continuously press LEFT button to exit to System Settings Main Menu.

DASH BOARD

SLIDING METAL HOUSING

FRONT PANEL

*During setting up, pressing SETUP button can exit from System Settings Menu and resume normal playback.

TO DRAW THE CHASSIS OUT OF THE SLIDING METAL HOUSING, INSERT THE LEFT AND RIGHT KEY PLATES INTO THE RIGHT POSITION OF THE 2 SIDES OF THE CHASSIS.

NOTE

REMOVE THE DECK TRANSPORT

SCREWS BEFORE OPERATING IT.

REMOVE THE SLIDING METAL HOUSING

PRESS RESET BUTTON TO RESUM E

THE DISTORTED PROGRAM WHEN

THE LCD DISPLAY IMPROPERLY ANDRESET BUTTON SOME BUTTONS ARE INVALID.

TO INSTALL THE FRONT PANEL BACK TO THE UNIT CHASSIS, FIRSTLY MAKE THE LEFT GUIDE BLOCK HOLE AND THE LEFT CYLINDER LINE UP AND THEN COMBINE THEM, THEN MAKE THE RIGHT GUIDE BLOCK HOLE AND THE RIGHT CYLINDER LINE UP AND THEN COMBINE THEM, FINALLY FLIP THE FRONT PANEL UP TO THE PANEL HOUSING TILL IT CLIP INTO POSITION.

TO REMOVE THE FRONT PANEL FROM THE UNIT CHASSIS, FIRSTLY PUSH THE FRONT PANEL HOLD RIGHTWARDS AND THEN PULL THE LEFT SIDE OF THE FRONT PANEL OUTWARDS

The 4 parts of the System Settings Main Menu are described as follows:

A. General Setup Page

OSD Lang

TV Type

TV Display

MP3 MODE

PBC

HDCD

OSD Lang

This item is for selecting the language of the SYSTEM MENU and all operating prompt interface displayed during playback.

TO INSERT DISC INTO COMPARTMENT OR EJECT DISC OR REMOVE THE FRONT PANEL FROM THE UNIT CHASSIS, PRESS THE OPEN BUTTON TO FLIP DOWN THE FRONT PANEL.

TV Type

This product supports output of various TV Type, including PAL, AUTO, NTSC and PAL 60.

PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com